CNC Milling Machinist - 5-Axis Precision (2nd Shift)

Eaton; Euclid (OH); On-site; USD 50,971 - 53,726; Full time

Job summary

Eaton’s AER FMC Fuel Motion Control Systems division is seeking a CNC Milling Machinist for the Euclid, OH plant, 2nd shift. The role sets up, operates and maintains 5+ axis CNC equipment, performs inspections per ANSI Y14.5, and supports other operators as needed.

Minimum 6 years of CNC setup/operation experience and 6 years GD&T experience; 2 years on 4-5 axis machines. Requires GED/HS, and U.S. person status for export-controlled information.

Qualifications

• High School Diploma or GED from an accredited institution.
• Must reside within a 50-mile radius of Euclid, Ohio; no relocation benefit is provided.
• This position requires access to export-controlled information. To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.
• Minimum (6) six years set-up and operation of precision CNC equipment; of which (2) two years must be on precision 4 or 5 axis CNC milling machine equipment
• Minimum 6 Years GD&T Experience

Responsibilities

• Set-up, operate and maintain one or more pieces of computer-controlled equipment (machine tools, material transport systems) to produce in-process and finished dimensions on 5+ Axis Machines.
• Perform visual and dimensional inspections and maintain accurate documentation on a variety of parts in accordance ANSI Y14.5 and the Certified Operator program, QCP 23.0.
• Assistance may be given to other operators on proper operational procedures.
• Obtain, read and interpret complex prints, gages, programs, process sketches, set-up sheets, fixtures and tools.
• Use a variety of gages, electronic and mechanical (including performing standard CMM checks), to check product dimensions and determine conformance to specifications.

Skills

CNC milling

GD&T experience

5 axis machining

Safety/compliance

Education

High School Diploma or GED

Job description

Eaton’s AER FMC Fuel Motion Control Systems division is seeking a CNC Milling Machinist for the Euclid, OH plant, 2nd shift. The role sets up, operates and maintains 5+ axis CNC equipment, performs inspections per ANSI Y14.5, and supports other operators as needed.

Minimum 6 years of CNC setup/operation experience and 6 years GD&T experience; 2 years on 4-5 axis machines. Requires GED/HS, and U.S. person status for export-controlled information.