Aerospace Inspector: CMM & First Article QC

Aerotek; Fullerton (CA); On-site; USD 39,000 - 62,000; Full time

Job summary

Aerotek is seeking an Inspector for its Fullerton, CA aerospace operations. The role involves inspecting parts against engineering drawings, process specs, and test reports, with responsibilities spanning first article, in-process, and final inspections using CMM and precision tools.

The position supports calibration, NCR handling, and documentation, and requires at least two years of inspection experience, strong communication skills, and familiarity with mechanical/electrical inspection

Qualifications

• Experience in inspection, quality control, and quality inspection.
• Ability to use precision measuring equipment such as micrometers, calipers, pin gauges, rulers, hardness testers, CMM, levels, and radius gauges.
• Two years of experience performing inspections.
• Good communication skills, both written and verbal.
• Exposure to mechanical and/or electrical inspection techniques.

Responsibilities

• Perform general inspection work in receiving, first article, in-process, final, and shipping inspection.
• Serve as backup for equipment and tools management to ensure calibration is maintained.
• Take direction from the inspection lead for work assignments and guidance on technical matters.
• Familiarize with ARA inspection procedures and related work instructions, recommending improvements when applicable.
• Measure parts to verify dimensions using CMM and other measuring equipment.
• Test units for specification conformance using measuring test equipment.
• Stamp or approve acceptable parts and document results.
• Document Non-conforming Material Reports (NCR) and disposition accordingly.
• Work from engineering drawings and process specs.
• Maintain inspection records per procedures.
• Perform other duties as assigned.

Skills

Inspection experience

Quality control

Measurement equipment handling

Communication skills

Mechanical/Electrical inspection

Tools

CMM

Job description

Aerotek is seeking an Inspector for its Fullerton, CA aerospace operations. The role involves inspecting parts against engineering drawings, process specs, and test reports, with responsibilities spanning first article, in-process, and final inspections using CMM and precision tools.

The position supports calibration, NCR handling, and documentation, and requires at least two years of inspection experience, strong communication skills, and familiarity with mechanical/electrical inspection