Senior Electrical Engineer, Fuzing & Avionics Systems

Hardware FYI; Fort Collins (CO); On-site; USD 191,000 - 253,000; Full time

Benefits offered by this job

Equity grants

Comprehensive benefits

Job summary

Anduril Industries is seeking a senior electrical engineer to lead full-cycle PCB design, from requirement collection to bring-up and integration within armored/air-vehicle systems.

You will develop fuzing circuitry for missiles, define wire harnesses, and collaborate with vehicle teams while conducting system reviews and field tests. A strong background in electronics, SI/PI, and DoD standards is required.

Qualifications

• BS or higher degree in Electrical Engineering with 12+ years of experience.
• Experience designing, testing, and troubleshooting complex boards.
• Familiarity with Ethernet, CAN, I2C, SPI, PCIe, USB, etc.
• Active U.S. Secret clearance eligibility and travel for testing.

Responsibilities

• Full cycle PCB design from requirements to bring-up and integration.
• Develop fuzing circuitry for missile systems.
• Collaborate with vehicle teams on fuzing systems and interconnects.
• Create system interconnect diagrams and wire harnesses.
• Support and coordinate with other subsystems during testing.
• Vendor surveys and component sourcing evaluations.
• Lead design reviews and perform lab, ground, and flight tests.
• Low level firmware development for bring-up and testing.
• Root cause analysis in field operations.

Skills

Electrical design

Signal integrity

Power integrity

Firmware bring-up

Test equipment

Schematic capture

Education

BS or higher in Electrical Engineering

Tools

Altium

Eagle

Oscilloscopes

Logic analyzers

Thermal chambers

Job description

Anduril Industries is seeking a senior electrical engineer to lead full-cycle PCB design, from requirement collection to bring-up and integration within armored/air-vehicle systems.

You will develop fuzing circuitry for missiles, define wire harnesses, and collaborate with vehicle teams while conducting system reviews and field tests. A strong background in electronics, SI/PI, and DoD standards is required.