Injection Molding Setup Technician I

Entegris, Inc.; Colorado Springs (CO); On-site; USD 28,000 - 32,000; Full time

Benefits offered by this job

Compensation $20-23/hr

401(k) match

Health, dental & vision insurance

Flexible schedule

11 paid holidays

PTO

Education assistance

Values-driven culture

Job summary

Entegris, Inc. at the Colorado Springs site seeks a Setup Technician I to prepare, set up, and optimize injection molding equipment.

You will install molds, adjust processing parameters, perform startups, and verify readiness in line with established procedures and quality standards. You will collaborate with manufacturing, engineering, and quality teams to maintain stable operation, minimize downtime, and drive continuous improvement across molding processes, including maintaining SQCD

Qualifications

• High school diploma or GED required.
• 3-5 years of mechanical or injection molding setup experience preferred.
• Competency using powered hand tools, fasteners, and measurement devices.
• Intermediate molding and processing skills desired.
• Strong mechanical aptitude and attention to detail for safety and quality.
• Basic math, computer literacy, and data-entry skills; SAP experience preferred.
• Demonstrated problem-solving and troubleshooting in mechanical environments.
• Experience in continuous improvement activities (Kaizen/6S) preferred.

Responsibilities

• Monitor molded products for visual and dimensional conformity and take corrective action.
• Set up injection molding presses according to schedules and instructions.
• Prepare auxiliary equipment and inspect molds for cleaning or repair needs.
• Maintain a clean, safe work environment and follow safety procedures.
• Support SQCD goals and participate in daily improvements and visuals boards.

Skills

Mechanical setup

Tools & measurement

Molding skills

Attention to detail

Math & data entry

SAP experience

Problem solving

Kaizen/6S

Education

High school diploma or GED

Tools

SAP

Job description

Entegris, Inc. at the Colorado Springs site seeks a Setup Technician I to prepare, set up, and optimize injection molding equipment.

You will install molds, adjust processing parameters, perform startups, and verify readiness in line with established procedures and quality standards. You will collaborate with manufacturing, engineering, and quality teams to maintain stable operation, minimize downtime, and drive continuous improvement across molding processes, including maintaining SQCD