Advanced Electrical Panel & Wiring Assembler

Hennig; Machesney Park (IL); On-site; USD 42,000 - 54,000; Full time

Job summary

Hennig is seeking an Electrical Assembler II in Illinois to perform advanced electrical assembly, conduit installation, wiring, and panel terminations. You will interpret engineering drawings and ensure production requirements are met.

Responsibilities include reading schematics, installing conduit, crimping lugs, routing wires, and assembling control boxes to company standards. You will use measuring tools and safety practices while working at heights on enclosures.

Qualifications

• High School Diploma or GED required for mechanical assembly tasks.
• Ability to read and interpret electrical schematics and drawings in English.
• Experience in basic electrical assembly and component wiring is preferred.

Responsibilities

• Read and interpret electrical schematics, wiring diagrams, and drawings.
• Install 1/2-inch and 3/4-inch EMT conduit with correct spacing and alignment.
• Crimp lugs and ferrules per quality standards and procedures.
• Pull and route wires through wireways and paths for devices.
• Install cable protection around edges and abrasion points as needed.
• Assemble and wire control boxes per schematics and standards.
• Terminate and label wires in control panels per requirements.
• Work with two-way, three-way, and four-way switching circuits.
• Fabricate and terminate DLO cable and 500 MCM wire assemblies.
• Operate power tools and measuring devices; use levels for alignment.
• Work safely at heights using scissor/boom lifts and ladders.

Skills

Conduit installation

Wiring and labeling

Blueprint interpretation

Measurement skills

Safety procedures

Education

High School Diploma/GED

Tools

Scissor lifts

Boom lifts

Job description

Hennig is seeking an Electrical Assembler II in Illinois to perform advanced electrical assembly, conduit installation, wiring, and panel terminations. You will interpret engineering drawings and ensure production requirements are met.

Responsibilities include reading schematics, installing conduit, crimping lugs, routing wires, and assembling control boxes to company standards. You will use measuring tools and safety practices while working at heights on enclosures.