Lean Manufacturing Tech: Process & Line Setup

Jabil Circuit Sdn Bhd; Penang; On-site; MYR 30,000 - 54,000; Full time

Job summary

Jabil Circuit Sdn Bhd in Penang is seeking a Process/Assembly/Industrial/Technician to support IE Engineers in planning layout, line setup, and resource optimization. You will assist with new line setup and 6S activities, and you will collaborate to improve processes across production lines.

A Diploma or Certificate in an Engineering field is required, along with a basic understanding of manufacturing and assembly processes.

Qualifications

• Diploma / Certificate in an Engineering Field and/or training is required.
• Basic understanding of manufacturing and assembly processes.
• Familiarity with basic lean concepts and continuous improvement is an advantage.
• Able to define problems, collect data, establish facts, and draw valid conclusions.
• Able to write routine reports and correspondence.

Responsibilities

• Perform assembly and process tasks according to approved work instructions, drawings, and SOPs.
• Set up, operate, and troubleshoot assembly tools, jigs, fixtures, and production equipment.
• Support new process introductions, line setup, process changes, and pilot runs.
• Assist in time studies, work measurement, and process validation activities.
• Support Industrial Engineers in lean initiatives, productivity improvement, and waste reduction (e.g. Kaizen, line balancing).
• Provide feedback on assembly methods and suggest improvements to enhance efficiency and ergonomics.
• Assist in implementing standardized work and best practices across production lines.
• Maintain accurate records of process parameters, output, and issues encountered.
• Assist with updating work instructions, process flow documents, and visual aids.
• Support audits and compliance requirements as required.

Education

Diploma / Certificate in an Engineering Field and/or training

Job description

Jabil Circuit Sdn Bhd in Penang is seeking a Process/Assembly/Industrial/Technician to support IE Engineers in planning layout, line setup, and resource optimization. You will assist with new line setup and 6S activities, and you will collaborate to improve processes across production lines.

A Diploma or Certificate in an Engineering field is required, along with a basic understanding of manufacturing and assembly processes.