General Mechanical Technician

Metadyne Automate Sdn Bhd; Kajang; On-site; MYR 28,000 - 45,000; Full time

Benefits offered by this job

EPF/SOCSO/EIS

Annual leave

Medical leave

Panel clinic

OT allowances

Travel allowances

Accommodation provided

Uniform and PPE

Safety training

Job summary

Metadyne Automate Sdn Bhd seeks an hands-on assembler to build equipment from drawings and BOMs in our workshop. You will install and commission at customer sites, supporting start-up and punch-list closure until buy-off.

Experience with piping, welding, and mechanical assembly is preferred. Willingness to travel 1–3 weeks per project, with OT, and outstation allowances provided.

Qualifications

• Proficiency in reading mechanical drawings and BOMs.
• Experience with hand and power tools, measuring instruments.
• Basic Bahasa Malaysia and ability to read drawings/checklists.

Responsibilities

• Assemble equipment frames, panels, tanks and modules as per drawings and BOM.
• Fabricate and install piping and fittings (PVC/PP/PVDF/SS).
• Mount pumps, valves, sensors; route tubing; assist wiring dressing.

Skills

Reading drawings

Hand tools

Power tools

Measuring tools

Bahasa Malaysia

Travel readiness

Education

SKM 2/3 or SPM

Tools

Piping tools

Welding equipment

Job description

Assemble industrial equipment at our workshop, and install, hook up and support the same equipment at customer sites. You will build machines from drawings, then follow them to site until buy-off. On-the-job training provided — good hands and good attitude matter most.

Key responsibilities

Assemble equipment frames, panels, tanks and modules from mechanical drawings and BOM — cutting, drilling, tapping, bolting, sealing, leveling.

Fabricate and install process piping and fittings (PVC / PP / PVDF / SS): measuring, cutting, solvent cementing / threading, routing and clamping per drawing.

Mount pumps, valves, filters, heaters, sensors and pneumatic components; route tubing (CDA/N2) and assist basic wiring dressing.

Move in, position, level and anchor equipment at customer site; install interconnecting piping, ducting and hook-up to facility points (DI water, drain, exhaust, CDA).

Support start-up and commissioning: leak checks, flushing, function test, punch-list rectification until customer buy-off.

Carry out site service and warranty support visits (part replacement, adjustment, minor repair) as assigned.

Follow customer site rules: safety induction, PPE, cleanroom protocol / gowning where required, permit-to-work, housekeeping.

Record work done, materials used and site issues; report daily progress to project engineer.

About you

SKM Level 2/3 in Mechanical / Fabrication / Welding / Mechatronic, or SPM with hands‑on mechanical experience.

1–3 years in equipment assembly, piping, fabrication or machine installation preferred; fresh certificate holders with good attitude are welcome.

Able to read basic mechanical/piping drawings and use hand tools, power tools and measuring instruments (tape, level, caliper).

Plastic piping (PVC/PP/PVDF) or TIG/arc welding skill is an added advantage.

Willing to travel and work outstation at customer sites (sometimes 1–3 weeks per project), including OT, weekends and shutdown periods.

Physically fit — able to lift up to 20 kg, work at height on ladder/scaffold, and stand for long hours.

Basic Bahasa Malaysia; simple English to read drawings and checklists. Own transport to workshop preferred.

• EPF, SOCSO & EIS; annual leave, medical leave and panel clinic.
• OT at statutory rates; site / outstation allowance, travel claims and accommodation provided for outstation projects.
• Uniform, PPE and tools provided; training sponsored (safety passport, cleanroom, skills certification).