Production Test & Debug Engineer - RF/Board Focus

AST & Science, LLC; Midland (TX); In loco; USD 90.000 - 120.000; Tempo pieno

Descrizione del lavoro

AST SpaceMobile in Austin, Texas is seeking two hands-on Manufacturing Test & Debug Engineers/Technicians to support setup, ramp-up, and ongoing operation of our electronic manufacturing and test line Midband in Austin. This is a production-floor role focused on keeping the line running, rapidly identifying and resolving issues to maintain high yield and throughput.

You will troubleshoot at PCB/PCBA, component, fixture, cabling, instrumentation, and test-station level; read schematics; and drive

Competenze

• B.Sc. in Electrical/Electronics Engineering or equivalent hands-on experience.
• Strong electronics troubleshooting and board-level debugging skills.
• Experience in electronic manufacturing, production test, or similar environments.

Mansioni

• Support installation, setup, qualification, ramp-up and ongoing operation of test stations.
• Provide hands-on engineering support on the production floor.
• Troubleshoot and debug electronic assemblies, including RF and mixed-signal boards.
• Diagnose failures at board, component, connector, cable, fixture and test-station level.
• Read schematics, wiring diagrams, test procedures, and technical docs.
• Perform fault isolation, failure analysis and root-cause analysis.

Conoscenze

PCB troubleshooting

Test equipment

RF / mixed-signal debugging

Schematic reading

Formazione

B.Sc. Electrical/Electronics Engineering

Associate degree / hands-on experience

Strumenti

Oscilloscopes

DMMs

Power supplies

Spectrum analyzer

Descrizione del lavoro

AST SpaceMobile in Austin, Texas is seeking two hands-on Manufacturing Test & Debug Engineers/Technicians to support setup, ramp-up, and ongoing operation of our electronic manufacturing and test line Midband in Austin. This is a production-floor role focused on keeping the line running, rapidly identifying and resolving issues to maintain high yield and throughput.

You will troubleshoot at PCB/PCBA, component, fixture, cabling, instrumentation, and test-station level; read schematics; and drive