Precision PCB Rework Technician — Second Shift

Rocket-Ems; Santa Clara (CA); On-site; USD 35,817 - 41,328; Full time

Job summary

Rocket EMS is seeking a Touch-Up / Rework Technician to diagnose, repair, and rework PCBAs and mechanical assemblies. Strong soldering skills, documentation interpretation, and precision repair using hand tools and equipment are essential.

You will collaborate with Manufacturing, Test, Quality, and Engineering teams to ensure workmanship and IPC compliance, while maintaining ESD protocols in a manufacturing environment. Pay range shown below.

Qualifications

• Experience performing soldering and rework on electronic assemblies.
• Ability to work under microscope for fine-pitch components.
• Familiarity with SMT and through-hole component repair.
• Ability to read and interpret assembly documentation and engineering drawings.
• Knowledge of ESD handling practices.
• Strong attention to detail and manual dexterity.
• Ability to work independently and follow repair procedures.

Responsibilities

• Perform component-level rework and touch-up on PCBAs including SMT and through-hole components.
• Remove and replace electronic components using soldering irons, hot air rework stations, and other repair tools.
• Repair lifted pads, damaged traces, solder bridges, and other workmanship defects.
• Perform wire modifications, jumpers, and engineering changes per documentation.
• Interpret assembly drawings, schematics, BOMs, and work instructions.
• Use microscopes and inspection equipment to identify defects and verify repair quality.
• Conduct mechanical rework and assembly repairs including hardware replacement and structural corrections.
• Document rework activity in manufacturing systems or travelers.
• Support debug and test teams by troubleshooting assembly failures when required.
• Maintain ESD compliance and proper handling of sensitive electronics.
• Ensure repaired products meet IPC workmanship standards and internal quality requirements.

Skills

Soldering

Microscope inspection

Reading assembly docs

ESD handling

Attention to detail

Manual dexterity

Independent work

Tools

Soldering irons

Hot air rework station

Microscopes

Inspection equipment

Job description

Rocket EMS is seeking a Touch-Up / Rework Technician to diagnose, repair, and rework PCBAs and mechanical assemblies. Strong soldering skills, documentation interpretation, and precision repair using hand tools and equipment are essential.

You will collaborate with Manufacturing, Test, Quality, and Engineering teams to ensure workmanship and IPC compliance, while maintaining ESD protocols in a manufacturing environment. Pay range shown below.