Electrician: Wiring, Controls & System Diagnostics

Tic Inc; Abilene (TX); On-site; USD 55,000 - 75,000; Full time

Job summary

TIC_Craft in Abilene, TX, is seeking an Intermediate-level Electrical Technician to plan, lay out, install, test and repair wiring, fixtures, motors and control systems per plans, codes and standards.

You will interpret drawings, install conduit, set up control equipment, test systems, and work with high and low voltage setups. The role requires climbing, outdoor work in all weather, and overtime as needed.

Qualifications

• Must possess working knowledge and abilities for position.
• Ability to understand, follow and transmit written and oral instructions and communicate effectively with management/supervision.
• Ability to use hand tools, power tools and layout tools safely and efficiently.

Responsibilities

• Interpret drawings, sketches, software, plans and determine best work procedures, tools, equipment needed to troubleshoot and repair problems.
• Measure, cut, bend, thread, assemble and install electrical conduit; weld supports; install cable and duct banks; make terminations.
• Install control and distribution apparatus and fasten in place.
• Test and start up systems and continuity of circuit to ensure electrical compatibility and safety of components.
• Observe functioning of installed equipment or system to determine hazards and need for adjustments, relocation, or replacement.
• May be required to pull wire through conduit; connect wiring to lighting fixtures and power equipment.
• Work with high and low voltage systems.
• Disassemble and repair defective electrical equipment or systems.
• Operate electrical and mechanical hand tools, power, hydraulic, pneumatic and electrical tools.

Education

High school diploma or equivalent

Job description

TIC_Craft in Abilene, TX, is seeking an Intermediate-level Electrical Technician to plan, lay out, install, test and repair wiring, fixtures, motors and control systems per plans, codes and standards.

You will interpret drawings, install conduit, set up control equipment, test systems, and work with high and low voltage setups. The role requires climbing, outdoor work in all weather, and overtime as needed.