Aerospace Machinist, 3rd Shift, Gear & Shaft Certified

Eaton Corporation; Cleveland (OH); On-site; USD 62,000 - 70,000; Full time

Job summary

Eaton Corporation, Euclid, OH, seeks a Machinist-3rd Shift (Certified Gear & Shaft) to set up and operate drilling, milling, edge breaking, and finishing operations. The role requires GD&T proficiency, 2+ years machining, and adherence to quality standards.

The position is a 3rd shift role (12am–7am) with opportunities to participate in ANSI/quality programs and continuous improvement initiatives at the Euclid facility.

Qualifications

• High School Diploma or GED from an accredited institution.
• Must reside within a 50-mile radius of Euclid, Ohio. Active Duty military are exempt from the geographical requirement
• This position requires access to export-controlled information. To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.
• Minimum two (2) years of machining (Non-CNC acceptable).
• Minimum 2-year GD& T Experience (successful completion of Eaton Level 1 Advanced Training will be considered in lieu of this requirement).

Responsibilities

• Setup and operate finishing and grinding equipment to generate rough and finish dimensions on a variety of parts.
• Mount and align fixtures, adjust speeds/feeds, and load tooling to meet close tolerances.
• Read blueprints and perform quality checks with gauges.
• Perform degrease and oiling on hardware.
• Operate equipment with minimal assistance; handle lapping, balancing, milling, drilling, and deburring operations.
• Maintain lot traceability and records.
• Complete final stocking of finished products.
• Keep equipment and work area clean and perform minor maintenance.
• Chart and plot data per SPC.
• Move material within the cell.

Skills

Machining experience

GD&T knowledge

Quality inspection

Certified operator

5S

Education

High School Diploma or GED

Tools

Measuring gauges

Job description

Eaton Corporation, Euclid, OH, seeks a Machinist-3rd Shift (Certified Gear & Shaft) to set up and operate drilling, milling, edge breaking, and finishing operations. The role requires GD&T proficiency, 2+ years machining, and adherence to quality standards.

The position is a 3rd shift role (12am–7am) with opportunities to participate in ANSI/quality programs and continuous improvement initiatives at the Euclid facility.