Aerospace Composite Technician — 2nd Shift

General Atomics Aeronautical Systems; San Diego (CA); On-site; USD 48,000 - 72,000; Full time

Job summary

General Atomics Aeronautical Systems, Inc. (GA-ASI) is a world leader in remotely piloted aircraft and surveillance systems.

This 2nd shift position supports fabrication and assembly of composite materials in a loud manufacturing environment, following pre-determined procedures and using detailed blueprints. You will assist in mold prep, lay-up, trimming, drilling, sanding, and assembly with various adhesives and fasteners.

Qualifications

• Requires High School diploma or equivalent and two+ years of related experience.
• Able to read and comprehend blueprints and instructions, and perform simple math calculations.
• Must use hand tools and fixtures such as molds and mandrels.
• Ability to measure with scales, protractors and calipers.
• Respirator certification may be required.
• Work in a loud environment and lift up to 50 lbs.

Responsibilities

• Assist in preparation of molds and forms.
• Mark and cut tape and materials following templates or dimensions.
• Route, drill, trim, and sand to blueprint tolerances; vacuum bag parts for curing.
• Assist lay-up of composite materials to mold and build-up layers without wrinkles or air pockets.
• Assemble aircraft components using rivets and fasteners.
• Apply epoxy paints and coatings with spray equipment.
• Maintain clean, organized work area and proper material storage.
• Support quality processes and observe safety rules.

Skills

Verbal communication

Blueprint reading

Mathematical calculations

Hand tools usage

Measuring instruments

Respirator certification

Lifting up to 50 lbs

Education

High School diploma or equivalent

Tools

Rollers

Paper cutters

Scissors

X-acto knives

Electric heat gun

Molds and mandrels

Job description

General Atomics Aeronautical Systems, Inc. (GA-ASI) is a world leader in remotely piloted aircraft and surveillance systems.

This 2nd shift position supports fabrication and assembly of composite materials in a loud manufacturing environment, following pre-determined procedures and using detailed blueprints. You will assist in mold prep, lay-up, trimming, drilling, sanding, and assembly with various adhesives and fasteners.