You will build and integrate the avionics that fly our UAVs: flight controllers, power systems, payloads, communication links and ground-station interfaces. You will work closely with Engineering, Quality and Production, and guide junior technicians on the shop floor.
This is hands-on, precision work in an ESD-controlled production and R&D environment. You will test, troubleshoot and sign off what you build, and may support field trials and extended shifts when production demands.
Responsibilities
- Assemble and integrate flight controllers, GNSS, sensors, ESCs and power distribution units as per approved drawings.
- Fabricate wiring harnesses and carry out soldering, crimping and PCB rework to strict workmanship standards.
- Install, configure and test cameras, payloads, telemetry radios, antennas and ground control station interfaces.
- Run electrical checks, first power-on and functional tests using oscilloscopes, multimeters and electronic loads.
- Diagnose and rectify faults at harness, PCB and system level, and support root-cause analysis.
- Maintain build and test records, follow QC gates and SOPs, and guide junior technicians.
Requirements
- Diploma in Electronics, Electrical or Electronics & Communication Engineering; ITI with substantial hands-on experience may be considered.
- Four to six years in UAV, avionics, aerospace or defence electronics, or electronic system integration.
- At least two years of hands-on harness fabrication, soldering, crimping, PCB rework, testing and troubleshooting.
- Working knowledge of flight controllers, GPS/IMU, ESCs, power distribution, telemetry and UART, SPI and I2C interfaces.
- Confident use of oscilloscopes, multimeters and power supplies; able to read schematics, wire lists and BOMs.
- Disciplined approach to ESD, quality and documentation, with the ability to guide junior technicians.
Qualifications
- Diploma in Electronics, Electrical or Electronics & Communication Engineering
- ITI with substantial hands-on experience may be considered.
Nice to have
- Exposure to UAV, drone or defence electronics manufacturing under controlled production processes.
- Experience with RF links, long-range telemetry and antenna alignment or tracking.
- Familiarity with UAV cameras and payloads, GCS setup, or Linux-based modules such as NVIDIA Jetson.
- Experience guiding technicians and working to revision-controlled production documentation.