Sheetmetal Mechanic - RTP

Environmental Air Systems; Raleigh (NC); On-site; USD 52,000 - 76,000; Full time

Job summary

Environmental Air Systems in Raleigh, NC seeks a skilled sheet metal installer with at least five years of experience to install and layout HVAC ductwork. You will read ductwork and architectural drawings, perform quality control, and coordinate with other trades while following safety policies.

Must be able to lift up to 50 lbs and operate cranes or forklifts as needed; adherence to safety and standards is essential for success in this role.

Qualifications

• Minimum high school education or equivalent.
• At least five years of sheet metal experience.
• Must adhere to safety policies and regulations.
• Able to read ductwork and architectural drawings.
• Capable of lifting up to 50 lbs.
• OSHA 10 certification obtained within the last 5 years.
• Operate with cranes, boom trucks, lulls and forklifts safely.
• Welding and fabrication of supports for equipment.
• Knowledge of air flow: supply, return, exhaust.
• Quality control per manufacturers' instructions.
• Collaborate with other trades professionally.

Responsibilities

• Install HVAC duct systems according to plans.
• Lay out ductwork and fittings for efficient installation.
• Perform quality checks per specs and drawings.
• Coordinate with other trades to resolve conflicts.
• Identify and correct unsafe conditions on site.
• Read and interpret ductwork and architectural drawings.
• Operate cranes and heavy equipment safely.

Skills

HVAC installation

Team coordination

Duct layout

Reading drawings

Quality control

Safety compliance

Rigging signals

Welding fabrication

Airflow knowledge

Equipment rigging

Education

High school diploma or equivalent

OSHA 10 certification

Tools

Cranes

Boom trucks

Lulls

Forklifts

Job description

QUALIFICATIONS:Able to understand all aspects of HVAC installation.Be dependable and able to work different areas at a time with 4-5 people in each group.To be able to lay-out duct for installation and look ahead to keep work going smoothly.Employee must have a good working attitude.Needs to adhere to all EAS safety policies and regulations.Must be capable of spotting unsafe situations and correcting them as needed.Has to be able to sketch fitting for duct connections. Have knowledge of signals for rigging, and setting HVAC equipment with cranes, boom trucks, lulls, and forklifts.Have knowledge of Welding and fabrication of supports for equipment.Needs to know Air flow of systems as far as—Supply; Return; Exhaust.Needs to be able to do Quality Control to make sure that all HVAC inline Mechanical Devices are installed according to Manufactures Instructions.Needs to be able to work with other Trades in a Professional manner to correct any conflicts that may arise.Capable of reading not only duct work drawings, but Architectural drawings to locate rooms, ceiling elevations, columns.EDUCATION:Minimum of a high school education or equivalent.This Position requires a minimum of five (5) years of Sheet Metal experience.JOB REQUIREMENTS/SPECIAL SKILLS:Requires working in conditions of varying heat and cold and where noise levels are at or above 90 decibels.Courses in construction safety are a requirement.Be able to continue job if Superintendent is not available.Ability to lift up to 50 lbs.OSHA 10 certification obtained within the last 5 years is required.