Senior Design Lead - High Voltage, Low Power, UC, UP

HCLTech; Santa Clara (CA); Vor Ort; USD 180.000 - 240.000; Vollzeit

Zusammenfassung

HCL Technologies Limited is seeking a Senior Design Lead with 12+ years of experience in high voltage, low power electronics for UC/UP applications. The role emphasizes end-to-end sustenance, obsolescence management, rapid prototyping, and system integration.

The ideal candidate will lead design efforts for analog/digital boards, perform V&V, and drive DFx/PCB layout, leveraging ECAD tools like OrCAD, Altium, or Xpedition. Regulatory knowledge in IEC 60601 and FDA submissions is valued.

Qualifikationen

• Bachelor's degree in Electrical Engineering or equivalent required.
• 12+ years of related experience in design and development.
• End-to-end sustenance and obsolescence management experience.
• ECAD tools proficiency: OrCAD/Altium/Xpedition and PCB layout knowledge.

Aufgaben

• End to End Sustenance experience in obsolescence management, manufacturing issues, rapid prototyping, system integration, testing, V&V, and design transfer.
• Cost reduction of PCBA boards, Re engineering and Testing.

Kenntnisse

Sustenance management

Obsolescence management

PCB design

Rapid prototyping

System integration

Testing & V&V

Design transfer

Cost reduction of PCBA

Medical regulatory awareness

Interface protocols (I2C/UART/SPI/USB/

PCI)

ECAD tools (OrCAD/Altium/Xpedition)

Ausbildung

Bachelor's degree in Electrical Engineering

Tools

OrCAD

Altium

Xpedition

Jobbeschreibung

Career Opportunities: Senior Design Lead - High Voltage, Low Power, UC, UP (190689)

A minimum of a Bachelor’s degree is required, preferably in Electrical Engineering or equivalent, combined with at least 12+ years work-related experience.

End to End Sustenance experience in obsolescence management, manufacturing issues, PCB design, rapid prototyping, system integration, testing, V&V, and design transfer.

Cost reduction of PCBA boards, Re engineering and Testing.

Knowledge in medical product life cycle.

Design experience in Analog, Digital board design involving microprocessor, microcontroller, memory, sensors and amplifiers.

Hands on experience in Electronics & Embedded Product development

Experience in System level and PCBA level testing.

Knowledge in interface protocols like I2C,UART,SPI, USB, PCI.

Knowledge in high density cable design, harness and cabling.

Experience in ECAD tools like OrCAD or Altium or Xpedition for schematics generation and knowledge in PCB layout, DFx and Gerber release.

Experience in component engineering and BOM generation for prototype, pilot and production BOM.

Knowledge in IEC 60601, FDA submission and medical regulatory standards.

Knowledge in VAVE analysis, vendor discussions and qualifications.

Use of test equipment’s like oscilloscope, multimeter, flow meter, signal analyzers for testing and troubleshooting.

Proficiency in drafting test protocols and generating reports.

Experience in bench testing, system characterization, troubleshooting and verification.

Key Responsibilities

1. 1) End to End Sustenance experience in obsolescence management, manufacturing issues, rapid prototyping, system integration, testing, V&V, and design transfer.
2. 2) Cost reduction of PCBA boards, Re engineering and Testing.