RF & Microwave Engineering Technician (Prototyping & Test)

Dover Corporation; Salisbury (MD); On-site; USD 55,000 - 85,000; Full time

Job summary

Dover Corporation in Salisbury, MD is seeking Engineering Technicians to prototype and test filter products using design information, test equipment, and software. You will work with various filter technologies and RF hardware, perform measurements, and document results.

You must hold an associate degree in electronic technology or equivalent training, bring hands-on soldering experience, and demonstrate strong troubleshooting and communication skills in a fast-paced environment.

Qualifications

• Associates Degree in Electronic Technology or equivalent military training, with 5 years related RF/Microwave testing experience.
• If no degree, 10 years work experience required.
• Soldering experience or skills preferred; strong calibration, circuit function, drawings interpretation, and troubleshooting knowledge.

Responsibilities

• Under minimal supervision, prototype, troubleshoot, test, and support production-related issues in the engineering department.
• Set up and use test equipment such as network analyzers, signal analyzers, oscilloscopes, and multi-meters.
• Measure and interpret parameters like gain, noise figure, 1 dB compression, intermodulation, harmonics, and spurious signals.
• Accurately troubleshoot problems and communicate solutions to stakeholders.
• May work from schematics, drawings, data sheets, or verbal instructions with interpretation.
• Handle assignments requiring sound judgment and initiative.
• Apply electronic theory to configure, model, layout, prototype, build, test, troubleshoot, and modify electronic products.
• Assist engineers with design and development of new processes and/or products.

Skills

Communications

Documentation

RF testing

Education

Associates Degree in Electronic Technology

Job description

Dover Corporation in Salisbury, MD is seeking Engineering Technicians to prototype and test filter products using design information, test equipment, and software. You will work with various filter technologies and RF hardware, perform measurements, and document results.

You must hold an associate degree in electronic technology or equivalent training, bring hands-on soldering experience, and demonstrate strong troubleshooting and communication skills in a fast-paced environment.