Maintenance Tech - Nights

Sanderson Pipe Corporation; Clarksville (TN); On-site; USD 25,000 - 36,000; Full time

Job summary

Sanderson Pipe Corporation in Clarksville, TN is seeking a Tech I to support extrusion line operations and plant maintenance. The role requires hands-on fabrication using electric arc welding and cutting tools, with strict adherence to safety PPE and plant procedures.

You will troubleshoot hydraulic and pneumatic systems, read precision gauges, and assist with mechanical equipment like drill presses, grinders, and band saws. A High School Diploma or GED and basic experience are required.

Qualifications

• Ability to read a depth gauge, calipers, micrometers, and tape measure.
• Ability to read ohms, amps, and volts.
• Basic AC/DC motor knowledge, wiring and troubleshooting.
• Basic knowledge of hydraulic and pneumatic systems and troubleshooting.
• Understand NEMA codes.

Responsibilities

• Fabricate using electric arc welding and cutting torch.
• Troubleshoot and repair hydraulic and pneumatic systems.
• Operate drill press, grinders and band saws; troubleshoot related equipment.
• Understand bearings, shafts, pulleys, gearboxes and transmissions.
• Follow supervisor directions and perform other duties as assigned.

Skills

Reading gauges

Electrical readings

Motor troubleshooting

Education

High School Diploma or GED

Two years experience in related area

Tools

Electric arc welding

Cutting torch

Job description

The Tech I position is normally assigned to a Production Shift to ensure the smooth efficient operation of the extrusion lines and all other mechanical mechanisms within the plant. Techs are to wear all PPE for protection against safety hazards.

Supervisory Responsibilities:

None

Reports To:

Maintenance Manager

Duties/Responsibilities:

• Must be able to fabricate using electric arc, welder and cutting torch.
• Basic knowledge of hydraulic and pneumatic systems with ability to troubleshoot and repair.
• Knowledge of drill press, grinders and band saws/ basic knowledge of troubleshooting pneumatic and hydraulic equipment such as valves cylinders, and pumps.
• Basic knowledge of bearings, shafts, pulleys, reduction, and distribution gearboxes, transmissions, etc.
• Understand NEMA codes.
• Any other duties assigned by your supervisor.

Required Skills/Abilities:

• Ability to read a depth gauge, calipers, micrometers, and tape measure for basic machining and fabricating.
• Ability to read ohms, amps, and volts
• Basic AC/DC motor knowledge, wiring and troubleshooting

Education and Experience:

• High School Diploma or GED
• Minimum of two years of experience, training, or education on any of the above is a plus.

Physical Requirements:

• Must be able to lift up to 50 lbs. Assistance is required when lifting anything over 50 lbs.
• Must have no fear of heights and ability to climb ladders