CMM Inspector (PC-DMIS) – GD&T & QA Specialist

JM Fabrication; Arlington (TX); On-site; USD 34,000 - 48,000; Full time

Job summary

JM Fabrication Company LLC is seeking a CMM Operator / Quality Inspector with PC-DMIS experience to perform dimensional inspections of manufactured parts and assemblies using a Coordinate Measuring Machine (CMM) and precision gauges. The ideal candidate reads engineering drawings, applies GD&T, assesses measurement results, and documents findings; PC-DMIS programming experience is preferred.

This full-time Arlington, TX role reports to the Quality Manager and offers a hands-on manufacturing

Qualifications

• Two+ years of dimensional inspection in manufacturing with hands-on CMM operation.
• ,
• ,
• ] ,
• job_responsibilities_description:[
• Set up and operate CMM with PC-DMIS to run programs and generate inspection reports.
• Verify identification, drawing revision, inspection program, fixturing, probe qualification, and part alignment before accepting inspection results.
• Perform first article inspection (FAI), in-process inspection, final inspection, and receiving inspection as assigned.
• Read and interpret engineering blueprints, technical specifications, and GD&T per ASME Y14.5.
• Apply GD&T requirements to inspection setups and results, including datum reference frames, feature control frames, basic dimensions, position, profile, flatness, perpendicularity, parallelism, and runout.
• Interpret material condition requirements (MMC/LMC/RFS/bonus) where applicable.
• Use micrometers, calipers, height gauges, dial indicators, gauge pins, and surface plates for manual inspections and measurements.
• Investigate unexpected readings and escalate concerns about setup, programs, or drawings.
• Document inspection results accurately and maintain traceability.

Responsibilities

• Set up and operate CMM equipment using PC-DMIS to run approved inspection programs, review measurement results, and generate inspection reports.
• Verify part identification, drawing revision, inspection program, fixturing, probe qualification, and part alignment before accepting inspection results.
• Perform first article inspection (FAI), in-process inspection, final inspection, and receiving inspection as assigned.
• Read and interpret engineering blueprints, technical specifications, and GD&T per ASME Y14.5, using the revision required by the drawing or customer.
• Apply GD&T requirements to inspection setups and results, including datum reference frames, feature control frames, basic dimensions, position, profile, flatness, perpendicularity, parallelism, and runout.
• Interpret material condition requirements, including MMC, LMC, RFS, and bonus tolerance, where applicable.
• Use micrometers, calipers, height gauges, dial indicators, gauge pins, and surface plates to perform manual inspections and verify measurements.
• Investigate unexpected readings and escalated concerns involving part setup, alignment, inspection programs, or drawing interpretation.
• Document inspection results accurately and maintain traceability to the applicable part, job, drawing revision, and inspection equipment.
• Identify, document, and segregate nonconforming material according to company procedures. Communicate discrepancies promptly to Quality and Production.
• Support AS9102 first article inspection reports when required by the customer.
• Verify equipment calibration status, perform routine operator checks and cleaning, and report equipment damage or performance concerns.
• Support root cause investigations, corrective actions, and improvements to inspection methods.
• Maintain an organized inspection area and follow company quality and safety procedures.

Skills

PC-DMIS

CMM operation

GD&T reading

Inspection reporting

Blueprint reading

Tools

PC-DMIS programming

Job description

JM Fabrication Company LLC is seeking a CMM Operator / Quality Inspector with PC-DMIS experience to perform dimensional inspections of manufactured parts and assemblies using a Coordinate Measuring Machine (CMM) and precision gauges. The ideal candidate reads engineering drawings, applies GD&T, assesses measurement results, and documents findings; PC-DMIS programming experience is preferred.

This full-time Arlington, TX role reports to the Quality Manager and offers a hands-on manufacturing