CMM Inspector – PC-DMIS Quality Assurance Specialist

JM Fabrication; Arlington (TX); On-site; USD 55,000 - 75,000; Full time

Job summary

JM Fabrication is seeking a CMM Operator / Quality Inspector with PC-DMIS experience to perform dimensional inspections of manufactured parts and assemblies at our Arlington, TX facility.

The ideal candidate reads blueprints, applies GD&T per ASME Y14.5, and uses micrometers, calipers, height gauges, and surface plates to verify measurements. PC-DMIS programming is preferred, and the ability to communicate quality concerns to production is essential.

Qualifications

• Two or more years of dimensional inspection experience in manufacturing, including hands-on CMM operation.
• Ability to read engineering drawings and apply GD&T to actual part setups and measurements.
• Proficiency with precision measuring instruments and manual dimensional inspection.

Responsibilities

• Set up and operate CMM equipment using PC‑DMIS to run inspection programs and generate reports.
• Verify part identification, drawing revision, inspection program, fixturing, and alignment before accepting results.
• Perform first article, in-process, and final inspections as assigned.
• Interpret GD&T per ASME Y14.5 and apply datum references, feature control frames, and tolerances.

Skills

Dimensional inspection

Blueprint reading

Attention to detail

Tools

PC‑DMIS

Micrometers & calipers

Height gauges

Job description

JM Fabrication is seeking a CMM Operator / Quality Inspector with PC-DMIS experience to perform dimensional inspections of manufactured parts and assemblies at our Arlington, TX facility.

The ideal candidate reads blueprints, applies GD&T per ASME Y14.5, and uses micrometers, calipers, height gauges, and surface plates to verify measurements. PC-DMIS programming is preferred, and the ability to communicate quality concerns to production is essential.