AC/DC Motor Technician – Heavy Industry Repair & Testing

FLANDERS; Longview (TX); On-site; USD 52,000 - 76,000; Full time

Job summary

FLANDERS in Longview, TX, seeks an AC/DC Motor Technician to disassemble, inspect, repair, and reassemble complex electromechanical motors and equipment. You will run tests and document results, while maintaining thorough repair records and adhering to safety rules on high- and low-voltage equipment.

The role requires a high school diploma and at least two years of mechanical or repair experience, plus the ability to perform basic math.

Qualifications

• High school diploma or equivalent.
• At least two years of mechanical or repair experience.
• Ability to perform basic math functions including addition, subtraction, multiplication, division including understanding fractions.

Responsibilities

• Read job cards to determine job status, work authorizations/limitations, description of problems, and/or expected serviceability.
• Disassemble moderately complex electromechanical equipment noting parts identification, configuration, and condition.
• Assemble moderately complex motors and equipment including bluing and scraping sleeve bearings.
• Perform tests of electromechanical equipment and document accordingly including AC and DC drop test.
• Operate Megger DC Hypot, Surge Tester, AC Hypot Volt-Ohm Meter, Growler, Amp Meters, and Feeler Gauges, Tem. Chard Recorder, 810 Vibration Meter, and electrical testing up to 20,000 VDC as needed on jobs.
• Clean complex electromechanical equipment assemblies as needed using various methods and steps including but not limited to parts washers/steamers.
• Thoroughly inspect parts for wear and damage and record any worn or damaged parts.
• Measure parts for proper replacement or note proper replacement parts.
• Store parts accurately according to job status or work scope after the dismantling process.
• Replace and repair moderately complex defective mechanical and electromechanical assemblies including but not limited to bearings, brushes, brush holders, motor leads, gears, seals, impellers, mechanical switches, brakes, clutches, clutch rotors, tachs, fans, end shields, etc.
• Lift, tighten, adjust, and/or secure heavy objects to perform work duties.
• Maintain thorough paperwork throughout entire repair process including all test sheets from receiving unit description to Quality Control Checklist. Record accurately and on a timely basis.
• Pre-test electrical and mechanical equipment and ensure proper lubrication set up on test plate.
• Connect leads and test run on proper voltage. Observe any abnormalities in test run (heat/rubbing noise, etc.).
• Retest reassembled electromechanical equipment for proper output and operation.
• Observe safety rules for Low Medium Voltage Test Panel.
• Perform other duties as assigned.

Skills

Mechanical repair

Math basics

Education

High school diploma or equivalent

Job description

FLANDERS in Longview, TX, seeks an AC/DC Motor Technician to disassemble, inspect, repair, and reassemble complex electromechanical motors and equipment. You will run tests and document results, while maintaining thorough repair records and adhering to safety rules on high- and low-voltage equipment.

The role requires a high school diploma and at least two years of mechanical or repair experience, plus the ability to perform basic math.