Electronics Hardware Engineer

Adapt E; Zabrze; On-site; PLN 120,000 - 180,000; Full time

Job summary

Adapt E is seeking an Electronics Hardware Engineer to join our team in designing robust electronics for demanding applications. The role focuses on schematic capture, BOM preparation, and multi-layer PCB layout, with emphasis on EMC and industrial environments.

You will collaborate on prototype bring-up, verification, and provide technical support across the hardware development lifecycle, leveraging STM32/NXP/TI MCUs and Altium Designer.

Qualifications

• Minimum 5 years of experience in electronics hardware design.
• Proficiency with Altium Designer or similar EDA tools.
• Experience with industrial communication networks.
• Experience in power supply and power electronics design.
• Knowledge of ESD, EFT, and Surge protection techniques.
• Experience with galvanic isolation.
• Practical knowledge of SPI, I2C, and UART interfaces.
• Experience designing hardware based on STM32, NXP, or TI microcontrollers.

Responsibilities

• Electronic schematic design.
• Component selection and BOM preparation.
• Multi-layer PCB design and layout.
• Preparation of PCB manufacturing and assembly documentation.
• EMC design for industrial environments.
• Technical support and consulting during prototype bring-up and validation.

Skills

Altium Designer

Schematic design

PCB layout

Industrial networks

Power electronics

ESD/EFT/Surge protection

Galvanic isolation

SPI/I2C/UART

MCU families STM32/NXP/TI

EMC design

Tools

Altium Designer

Job description

Electronics Hardware Engineer

Scope of Work

• Electronic schematic design
• Component selection and BOM preparation
• Multi-layer PCB design and layout
• Preparation of PCB manufacturing and assembly documentation
• EMC design for industrial environments
• Technical support and consulting during prototype bring-up and validation

Requirements

• Minimum 5 years of experience in electronics hardware design
• Proficiency with Altium Designer or similar EDA tools
• Experience with industrial communication networks
• Experience in power supply and power electronics design
• Knowledge of ESD, EFT, and Surge protection techniques
• Experience with galvanic isolation
• Practical knowledge of SPI, I2C, and UART interfaces
• Experience designing hardware based on STM32, NXP, or TI microcontrollers

Nice to Have

• Experience with industrial communication protocols such as PROFINET, EtherCAT, or similar
• Experience designing products for CE compliance
• Knowledge of EMC standards and practical EMC testing/debugging
• Experience with hardware for drone detection or RF-based sensing systems
• Good understanding of RF fundamentals, including electromagnetic waves, frequency bands, signal propagation, impedance matching, and RF signal paths
• Practical experience with RF hardware components such as amplifiers, low-noise amplifiers (LNA), attenuators, filters, mixers, couplers, splitters, and RF switches
• Experience with antennas, RF front-end design, receivers, and signal conditioning
• Familiarity with spectrum analysis, RF measurements, and laboratory equipment such as spectrum analyzers, signal generators, VNAs, and oscilloscopes
• Experience selecting RF components and designing PCB layouts for high-frequency signals
• Knowledge of shielding, grounding, isolation, and interference mitigation in RF and mixed-signal hardware