Electrical Engineer – Underwater Robotics & Production

Tethys Robotics; Zürich; Hybrid; Vertraulich; Vollzeit

Benefits dieser Stelle

Ownership over core systems

Flat hierarchies

Opportunity to grow with the company

Zusammenfassung

Tethys Robotics, Zürich-based ETH Zürich spin-off, is seeking a hands-on Electrical Engineer to own electrical subsystems in underwater robots, from PCB design to embedded firmware, as we move from prototype builds to repeatable production.

You will design wiring, develop firmware in C/C++, integrate sensors and actuators, and collaborate across mechanical and software teams to deliver robust, manufacturable systems for challenging subsea environments.

Qualifikationen

• Degree in Electrical Engineering, Mechatronics, Robotics or related field.
• Hands-on PCB design with modern tools; firmware in C/C++ on embedded targets.
• Experience with microcontrollers, power electronics and sensor/actuator interfaces.
• Ability to own technical problems from design to tested solution.

Aufgaben

• Develop and improve electrical architecture for underwater robots.
• Design PCBs and electrical subsystems, power distribution and interfaces.
• Develop low-level embedded firmware in C/C++.
• Create drivers/interfaces for sensors/actuators and integrate with mechanical teams.
• Design wiring harnesses; perform PCB bring-up, testing and debugging.
• Support component selection, sourcing and lifecycle management.
• Prepare subsystems for certification and documentation.
• Contribute to future generations of Tethys platforms.

Kenntnisse

PCB design

C/C++

Embedded systems

Power electronics

Microcontrollers

System integration

CAN/UART/SPI/I2C

Electrical engineering

Project ownership

Ausbildung

BSc/MSc Electrical Engineering

Mechatronics/Robotics

Tools

Altium

KiCad

Embedded toolchains

Jobbeschreibung

Tethys Robotics, Zürich-based ETH Zürich spin-off, is seeking a hands-on Electrical Engineer to own electrical subsystems in underwater robots, from PCB design to embedded firmware, as we move from prototype builds to repeatable production.

You will design wiring, develop firmware in C/C++, integrate sensors and actuators, and collaborate across mechanical and software teams to deliver robust, manufacturable systems for challenging subsea environments.