SMT Touch-Up Rework Operator (Swing Shift)

Unigen Corporation; Newark (CA); On-site; USD 27,552 - 33,062; Full time

Benefits offered by this job

401(k) matching

Job summary

Unigen Corporation in Newark, CA is seeking a Touch-Up Rework Operator on swing shift to perform hand soldering and rework tasks for SMT and through-hole components, following IPC-A-610 guidelines.

You will clean PCBs, trim leads, and support ECO and MPI instructions, with training and cross-training opportunities in a dynamic EMS environment; prior 1-3 years manufacturing experience preferred.

Qualifications

• Prior on the job 1-3 years or more practical manufacturing experience.
• User knowledge of ESD, Board handling, and Safety Practices including Personal Protective Equipment.
• User knowledge of components and their polarity, including resistors and capacitors.
• User knowledge of IPC-610 and J-STD-001 Soldering Standards.
• User Knowledge of latest revision-class 3 workmanship criteria is a plus.

Responsibilities

• Hand solder & Touch-up Rework for SMT (Surface Mount Technology) & Through-hole components and Jumper wire
• Remove/install components as per IPC-A-610
• Touch up solder joints & trimming leads
• Clean PCBs, cleans workpieces, using chemical solutions, files, wire brush
• Perform rework based on the ECO, Process Deviation, and MPI instruction using a specific type of solder or Flux
• Install and hand solder all 2nd ops. & SMT parts/components as required per MPI, deviation, and unique rework processes
• Check and inspect task results against predetermined standards
• Communicate all issues found during hand soldering to the Production Leader
• Demonstrate work methods to new hires
• Share best practices, assist in minor troubleshooting
• Actively participate in cross-training

Skills

ESD knowledge

Board handling

Safety practices (PPE)

IPC-610 knowledge

J-STD-001 soldering standards

Polarity knowledge

Job description

Unigen Corporation in Newark, CA is seeking a Touch-Up Rework Operator on swing shift to perform hand soldering and rework tasks for SMT and through-hole components, following IPC-A-610 guidelines.

You will clean PCBs, trim leads, and support ECO and MPI instructions, with training and cross-training opportunities in a dynamic EMS environment; prior 1-3 years manufacturing experience preferred.