Saw Operator

Leggett & Platt; Fort Worth (TX); On-site; USD 34,000 - 52,000; Full time

Job summary

Leggett & Platt in Fort Worth, TX is seeking a production support role to operate cutting equipment and maintain sample inventories. You will cut material into samples, keep shelves stocked, and assist in preventive maintenance of saw equipment while performing quality checks.

The role requires reading and writing, basic math, precision, and the ability to follow written and verbal instructions. Must be able to lift up to 50 lbs and work in an environment with PPE usage.

Qualifications

• Reads, writes, and counts accurately.
• Basic math, English, use a tape measure, weight scale, and micrometer.
• Able to follow both written and verbal work instructions.
• Good communication skills.
• Detail oriented and able to adapt to changing tasks.

Responsibilities

• Operate cutting equipment and prepare samples for shelves.
• Maintain cut list and schedule for sample inventory stock.
• Support preventive and predictive maintenance of saw equipment.
• Perform quality checks on materials and processes.
• Assist Sample Clerk as needed.

Skills

Reading and writing

Basic math

Attention to detail

Communication

Prioritization

Safety awareness

Tools

Tape measure

Micrometer

Weight scale

Pallet jack

Job description

Reports To:

Sample Department Supervisor

Job Summary:

This position is responsible for the following:

• Operate cutting equipment: Band saw, rotating knife saw and die press
• Cut material to standard sample size; adjust as required
• Maintain cut list schedule to sample inventory stock
• Pull roll stock per the schedule
• Load and Unload rolls as needed
• Maintain organization of roll stock and shelves
• Bagging cut samples properly following quality checks and requirements
• Stocking sample inventory

Qualifications:

Must haves for this position:

• Be able to read, write, and count correctly
• Basic Math, English, use a tape measure, weight scale, and micrometer
• Be able to follow both written and verbal work instruction
• Have good communication skills
• Be detail oriented
• Be able to change tasks, prioritize, and re-prioritize frequently and able to follow-up on work tasks as needed in a timely manner
• Be able to bend, twist, push, pull, and lift (Up to 50lbs; anything heavier than that should be a two-person lift)
• Wear proper Personal Protection Equipment (PPE) when applicable
• Must work in an uncontrolled temperature environment
• Operate a pallet jack

Primary Duties:

• Cut material into samples to keep shelves stocked
• Responsible for communicating and assisting in the preventive and predictive maintenance of saw equipment
• Perform other job functions as directed by supervisor
• Quality check
• Assist Sample Clerk’s when needed

Quality:

• Adhere to material cut standards
• Review material after first cuts to inspect for quality of material

Safety:

• Must commit to creating a culture where partners are protecting partners- "You See Something, Say Something!"
• Must comply with all company policies and procedures listed in the Leggett & Platt Employee Handbook
• Report all incidents, accidents, and near-misses to your supervisor immediately
• Assist in recognizing, responding, reporting, and eliminating hazards and assuring safety compliance
• Must participate in:
  • On-the- Job (OJT) Training documentation
  • Use of CAR/PARs (Corrective / Preventative Actions)
  • Incident/Accident/Near-Miss Investigations to determine root cause
  • Use of required PPE
  • Participation in training events
  • Good housekeeping in the work area and entire company grounds
• Must understand and commit to:
  • No personal cell phone use on the production floor; Active cell phone use does not go beyond breaks and lunches
  • No horseplay, yelling, or violence in the workplace
  • No eating or open drinks are allowed on the production floor

Environmental:

• Commit to environmental preservation through:
  • Stormwater Pollution Prevention
  • Participation in recycling initiatives
  • Proper use of waste containers
  • Participation in training events

Requirements:

• You must be able to perform all job-related duties on or about: 90 days