A complete application in a minute
Tailored resume and cover letter, ready to send.
Zala Machine Co. in Hillsborough, New Jersey is hiring a Manual Lathe Machinist to turn parts from a print and stock on a traditional engine lathe, with no CNC.
Most jobs are one-off or short-run for industrial customers, including shafts, sleeves, bushings, and threaded components. You will read prints, set up carefully, measure your work with micrometers, calipers, indicators and bore gauges, and hold tolerances.
$26–$34 an hour Up to 10 hours overtime a week Full time, Mon–Fri 7:00–5:30 Paid time off Health insurance, half paid Mówimy po polsku
This is a manual lathe job for a machinist who can take a print and a piece of stock and turn it into a finished part, with no program doing the work. Most of what runs on our manual lathes is one-off and short-run work for industrial customers: shafts, rolls, sleeves, bushings, extruder parts and threaded components, made to print or rebuilt from a worn original.
Every job is different. You will indicate parts in the chuck or between centers, carry long shafts in the steady rest, single-point threads, bore, face and turn tapers, and hold the tolerances on the print. Many jobs arrive as a worn part or a sketch rather than a finished drawing, so judgment matters as much as speed.
You have real time on a manual engine lathe, you read prints well, and you measure your own work with micrometers, calipers, indicators and bore gauges. You take care with setups, you check before you cut, and you take pride in a part that is right the first time.
Manual lathe work is the foundation of the trade, and it is where our founder started. If you want to add manual milling, grinding or CNC setup and programming, we will teach you on real jobs.
A three-generation family machine shop in Hillsborough, New Jersey, founded in 2002. Mówimy po polsku: we speak Polish in the shop. See all our machinist jobs and our large lathe turning work.
A long shaft being turned on one of our manual lathes.
A thread cut into a shaft on the manual lathe.