Maintenance Technician II: CNC, PLC & PM Pro

Fox Factory; Gainesville (GA); On-site; USD 41,000 - 62,000; Full time

Benefits offered by this job

Medical

Dental

Vision

Health Spending and Dependent Care

Disability and Life Insurance

401k plan with employer matching

Job summary

Fox Factory seeks a maintenance technician to repair, service, and maintain ride dynamics products, primarily in an off-road vehicle environment. You will perform PMs, install equipment, and troubleshoot CNC systems while following safety protocols.

Qualifications include a high school diploma or OEM training and 2+ years in manufacturing with CNC troubleshooting. Strong reading of schematics and ability to work independently or in a team are required.

Qualifications

• 2+ years of experience in a manufacturing environment with CNC troubleshooting.
• Experience reading electrical/mechanical schematics and assembly instructions.

Responsibilities

• Use a electrical meter to check voltage and ohms.
• Wire in single phase motors, receptacles and sensors.
• Repair CNC equipment mechanically and electrically.
• Identify and repair pneumatic/hydraulic systems.
• Troubleshoot and solve production equipment issues.
• Read part manuals, schematics and troubleshooting guides.
• Setup and operate CNC equipment.
• Assist with installing new equipment per engineering layouts.
• Maintain 80% PM compliance.
• Follow safety requirements including LOTO.
• Operate a manual mill and lathe.
• Keep CMMS records up to date.

Skills

CMMS logging

Gauges & measurement tools

PLC-based machinery

Maintenance technician level 2

Troubleshooting

Reading schematics

Education

High school diploma or OEM training

Tools

CMMS

PLC-based controller

CNC equipment

Job description

Fox Factory seeks a maintenance technician to repair, service, and maintain ride dynamics products, primarily in an off-road vehicle environment. You will perform PMs, install equipment, and troubleshoot CNC systems while following safety protocols.

Qualifications include a high school diploma or OEM training and 2+ years in manufacturing with CNC troubleshooting. Strong reading of schematics and ability to work independently or in a team are required.