Maintenance Millwright

Allegiance Staffing; Oxford (AL); On-site; USD 42,000 - 54,000; Full time

Job summary

Allegiance Staffing is seeking a maintenance technician to perform preventative maintenance and install machinery in an industrial setting in Oxford, Alabama.

You will start up boilers, inspect systems, repair air compressors, read meters, and ensure safety and 5S compliance. The role requires a degree or equivalent and 6–12 months related experience, plus ability to lift up to 50 pounds.

Qualifications

• Associate’s degree (A.A.) or equivalent from a college or technical school.
• 6–12 months of related experience or training, or equivalent combination of education and experience.
• The job requires standing, walking, sitting, using hands, reaching, stooping, kneeling, crawling, and talking/listening.

Responsibilities

• Start up boiler, daily check and adjust controls; monitor charts.
• Check oil in air compressor and repair components such as valves and gaskets.
• Maintain pumps, gear boxes, fans, belts, bearings and related parts.
• Inspect and clean work area; operate forklift for loading/unloading.
• Fill out work orders, requisitions and obtain purchase signatures.
• Perform carpenter tasks with drills, saws and wrenches as needed.
• Assemble machines and secure to foundations; weld or rivet as required.
• Replace lights and perform basic electrical tasks; maintain safety procedures.
• Follow Environmental, Quality, Health, Safety & 5S policies and procedures.

Skills

Physical dexterity

Manual dexterity

Lifting up to 50 pounds

Stamina

Vision requirements

Education

Associate's degree (A.A.) or equivalent

Tools

Forklift operation

Job description

The purpose of this position is to perform preventative maintenance, install machinery and equipment in industrial establishment.

Key Responsibilities:

• Start up boiler, blow down once daily, and check press and water levels.Change all charts on temperature and humidity controls.
• Check oil in air compressor. Repair air compressor, such as replacing bad valves, gaskets, governors. Read gas meters, water meters, calibrate temperature controls, such as bearings, shaft, etc.
• Pull motors, change and repair valves, gaskets, worn out parts, etc. Repair fans on roof, replace bearings, belt, worn parts, etc. Repair pumps and gear boxes.
• Performs Inspections. Clean up work area daily. Operate fork lift to load and unload equipment. Fill out work orders, material requisitions and get signatures to authorize purchases.
• Perform carpenter duties as needed. Use drills, saws, grinders, pipe wrenches, threading machines.
• Assembles machines, and bolts, welds, rivets, or otherwise fastens them to foundation or other structures.
• Replace lights, fuses. Perform general electrical work, change solenoids, run water, air piping, etc.
• Comply with Environmental, Quality, Health, Safety & 5S objectives, polices & programs, and relevant procedures.
• Performs other position-related duties as assigned.

Required Qualifications:

• Associate's degree (A. A.) or equivalent from college or technical school;
• 6 to 12 months of related experience and/or training; or,
• Equivalent combination of education and experience.
• While performing the duties of this job, the employee is occasionally required to stand; walk; sit; use hands to finger, handle, or feel; reach with hands and arms; stoop, kneel, crouch, or crawl and talk or hear.
• The employee must occasionally lift and/or move up to 50 pounds.
• Specific vision abilities required by this job include close vision and ability to adjust focus.