Machinist (Grades 7 - 9)

General Dynamics Bath Iron Works; Brunswick (ME); On-site; USD 48,000 - 54,000; Full time

Job summary

General Dynamics Bath Iron Works in Bath, ME is seeking a Machinist (Grades 7-9) to set up and operate machine shop equipment, including lathes, drills, grinders, and presses, with CNC experience.

Candidates should have 3+ years in the Machinist Trade, read blueprints, understand G-code, and read measuring tools such as micrometers and calipers; the role requires precise manual and numeric skills.

Qualifications

• Minimum 3 years demonstrated experience in the Machinist Trade.
• Must be able to read blue prints.
• Must be able to demonstrate knowledge and use of G-code.
• Must be able to read measuring tools: tape measure, micrometers, calipers, dial indicators, etc.

Responsibilities

• Operate machine shop equipment including lathes, radial drills, grinders, presses, punch presses, cut-off saws, milling machines, and CNC equipment.
• Set-up and operate equipment with minimal training based on prior experience.
• Perform Machinist Trade tasks as assigned.

Skills

Blueprint reading

Measuring tools reading

Education

High school diploma or GED

Technical CNC training

Tools

G-code

Job description

Machinist (Grades 7 - 9)

Location

US-ME-Bath | US-ME-Brunswick | US-ME-Brunswick | US-ME-Bath

The pay for this position ranges from $35.15/hr - $39.03/hr.

This is an experienced position to work in the Machinist Trade. Machinists primarily set-up and operate machine shop equipment including (but not limited to): lathes, radial drills, grinders, presses, punch presses, cut-off saws, milling machines, HBM, VTL, rolls, sheers, brakes, and burning machines.

Applicants hired into this position shall generally be able to operate most equipment with minimal training based on prior experience, including CNC operated equipment. Machinists may be assigned any of the Machinist Trade tasks.

Required/Preferred Education/Training

Preferred:

• High School Diploma or GED

Required:

• Technical school or at least two years of training in CNC machine operation.
• Knowledge of G-code.

Required/Preferred Experience

Required:

• Minimum 3 years demonstrated experience in the Machinist Trade.
• Must be able to read blue prints.
• Must be able to demonstrate knowledge and use of G-code.
• Must be able to read measuring tools: tape measure, inside and outside micrometers, Vernier or dial calipers, dial indicators, etc. and perform simple math calculations.
• Must meet the requirements of the Machinist physical task analysis.