Machine Operator (2nd Shift)

RBC Bearings; California (MO); On-site; USD 28,000 - 33,000; Full time

Job summary

Industrial Tectonics Bearings is seeking an experienced machine operator to run production jobs, change tools, and assist with tool selection from the crib. You will verify part conformance with precision measurements and participate in first article inspections.

The role requires you to move between machines as needed in a floater capacity, and to sharpen high-speed tools under supervision. This position is based in California with compensation described below.

Qualifications

• Operates machine tools to machine parts on a production basis.
• Reads process sheets and follows supervisor instructions.
• Uses micrometers, calipers and gages to check work after each operation.
• Performs first article inspection and obtains an inspection buy-off after the run.
• Holds a floater position, moving between machines as assigned.
• Grinds high speed tools using sharpening equipment under supervision.

Responsibilities

• Operate machine tools and change tools as required to maintain setup.
• Assist in procuring proper tools from Tool Crib.
• Verify conformance of parts and obtain inspection buy-off.
• Plot accurate charts as required by Quality Control.

Tools

Micrometers

Calipers

Gages

Drill sharpening machine

Job description

Operates, in the manner instructed, any machine tool to machine parts from all materials on a production basis. The incumbent will change tools as required to maintain the set-up.

Assists in making a set-by by procuring proper tools from the Tool Crib; by making minor adjustments, by interpreting process sheets and by following clearly detailed instructions of the supervisor or other machinist designated by the supervisor.

Secures first article inspection to verify established set-up and continues to check parts for conformance to production standards during the course of the run. At the completion of the run, the incumbent obtains an inspection buy off before going to the next job.

Uses precision measuring devices such as micrometers, calipers and various gages to check work after each operation. Incumbent is responsible for plotting accurate charts as required by Quality Control.

Incumbent holds a floater position and moves from machine to machine as requested by supervisor.

Operator grinds high speed tools, such as tool bits and drills, using drill sharpening machine, etc., under the detailed instructions from his\/her supervisor or other machinist designated by the supervisor.

Disclaimer The above statements are intended to describe the general nature and level of work being performed by people assigned to this function. They are not intended to be an exhaustive list of all responsibilities, duties or skills required of incumbents.

MIN: $20.00 to $24.00

• Please note that the salary range information is only applicable to California. This range is the company's good faith and reasonable estimate of the compensation for this role based on the position's responsibilities, qualifications, experience, and other relevant factors. Actual compensation may vary depending on the selected candidate's specific experience, education, skills, and other relevant factors.

Equal Opportunity Employer Industrial Tectonics Bearings is an equal opportunity employer. All qualified applicants will receive consideration for employment without regard to race, color, religion, gender, sexual orientation, gender identity, national origin, disability, or veteran status.

This role is subject to compliance with the International Traffic in Arms Regulations (ITAR) and the Export Administration Regulations (EAR), which requires the incumbent to be either a US citizen, lawful permanent resident [“green card” holders] or have refugee or asylee status.