Industrial Electrician & Controls Specialist

Tic Inc; Shepherd (TX); Vor Ort; USD 54.000 - 78.000; Vollzeit

Zusammenfassung

TIC - The Industrial Company is seeking an intermediate-level electrician to plan, lay out, install, test and repair wiring, fixtures and control systems on a construction/industrial site in Texas. You will work with high- and low-voltage equipment and ensure compliance with plans, codes and safety standards.

Responsibilities include interpreting diagrams, installing conduit, testing systems, and performing start-ups while maintaining safe practices and conforming to project rules.

Qualifikationen

• High school diploma or equivalent required.
• Ability to read drawings, sketches and plans.
• Willingness to pass pre-access drug and alcohol testing and fit-for-duty medical.
• Must observe safety and project rules.

Aufgaben

• Interpret drawings, sketches and plans to determine procedures and tools.
• Measure, cut, bend, thread, assemble and install electrical conduit; weld supports; install cable and duct banks; make terminations.
• Install control and distribution apparatus and fasten in place.
• Test and start up systems and verify circuit continuity for safety.
• Observe equipment to identify hazards and determine need for adjustments or replacement.
• Pull wire through conduit; connect wiring to fixtures and power equipment.
• Work with high and low voltage systems.
• Disassemble and repair defective electrical equipment or systems.
• Operate electrical and mechanical hand tools, power, hydraulic, pneumatic tools.

Kenntnisse

Interpret drawings

Troubleshooting

Electrical wiring

Safety compliance

Ausbildung

High school diploma or equivalent

Tools

Electrical tools

Conduit installation

Power tools

Jobbeschreibung

TIC - The Industrial Company is seeking an intermediate-level electrician to plan, lay out, install, test and repair wiring, fixtures and control systems on a construction/industrial site in Texas. You will work with high- and low-voltage equipment and ensure compliance with plans, codes and safety standards.

Responsibilities include interpreting diagrams, installing conduit, testing systems, and performing start-ups while maintaining safe practices and conforming to project rules.