Industrial Electrician & Controls Installer

Tic Inc; Abilene (TX); On-site; USD 52,000 - 76,000; Full time

Job summary

TIC Inc in Abilene, TX is seeking an electrician to plan, lay out, install, test and repair wiring, fixtures, motors and control systems. The role requires intermediate experience and the ability to work with high and low voltage systems.

You will read drawings, interpret plans and select procedures and tools to troubleshoot and repair problems safely in varying outdoor conditions. Candidates should meet the listed education requirements and be able to lift and work at heights.

Qualifications

• Interprets drawings, sketches, plans and determines best work procedures and tools.
• Requires ability to understand and follow written and oral instructions.
• Must be able to use hand and power tools safely and efficiently.

Responsibilities

• Interpret drawings and plans to determine procedures, tools, and equipment needed.
• Measure, cut, bend, thread, assemble and install conduit; weld supports; install cable and duct banks; make terminations.
• Install control and distribution apparatus and secure in place.
• Test and start up systems and verify circuit continuity for safety and compatibility.
• Observe equipment to identify hazards and necessary adjustments or replacements.
• Pull wire through conduit and connect wiring to lighting fixtures and power equipment.
• Work with high and low voltage systems.
• Disassemble and repair faulty equipment or systems.
• Operate electrical and mechanical hand, power, hydraulic, pneumatic tools.

Skills

Interpreting drawings

Troubleshooting

Electrical wiring

Use of hand tools

Use of power tools

Layout tools

Education

High school diploma or equivalent

Tools

Hand tools

Power tools

Layout tools

Job description

TIC Inc in Abilene, TX is seeking an electrician to plan, lay out, install, test and repair wiring, fixtures, motors and control systems. The role requires intermediate experience and the ability to work with high and low voltage systems.

You will read drawings, interpret plans and select procedures and tools to troubleshoot and repair problems safely in varying outdoor conditions. Candidates should meet the listed education requirements and be able to lift and work at heights.