Electrical Engineer I: CNC Controls & Cabling

Paycom - ATS; Oxnard (CA); On-site; USD 62,000 - 83,000; Full time

Job summary

Haas Automation in Oxnard, CA is seeking an Electrical Engineer 1 to integrate, test, and maintain electrical systems for CNC control units, under supervision. You will design cabling, write ECOs, manage configurations, and sustain production activities on-site.

Relocation to Henderson, NV by February 2027 is required. Travel 0–5% and strong skills in SolidWorks, Altium/Mentor Graphics, and testing hardware are preferred.

Qualifications

• Ability to read and understand electrical schematics.
• Proficiency in SolidWorks is required; experience with SolidWorks routing is preferred.
• Knowledge of Altium or Mentor Graphics for schematic and board layout evaluation is a plus.
• Strong communication skills and ability to communicate technical ideas clearly.
• Analytical and problem-solving abilities.
• Knowledge of NEC and/or NFPA79 is a plus.
• Must have experience with general test equipment like oscilloscopes, multimeters, and current probes.
• Experience using Microsoft Office applications, TEAMS is a plus.
• Experience with an ERP system such as SAP or equivalent is a plus.
• Honesty, integrity, and adherence to company rules, procedures, and policies.
• Experience in electronics control cabinet design is a plus.
• Knowledge of induction motors and AC servo motors is considered an asset.
• 0-5% Travel Required.

Responsibilities

• Design and implement cabling systems specific to electro‑mechanical hardware based on best‑practices.
• Write Engineering Change Orders (ECO) for BOM modifications and/or creation.
• Oversee and manage configurations for CNC control systems.
• Sustain production activities as required.
• Evaluate alternate source components and assemblies to ensure requirements are met for existing designs, sustaining, and/or cost reduction.
• Conduct testing and/or manage pilot runs for new components or assemblies.
• Propose and implement problem solutions through analysis, problem definition, and requirement generation.
• Create engineering documentation for solutions.
• Investigate and mitigate any failures in existing designs.
• Follow company protocols, elevate issues impacting workflow or quality as needed.
• Employees are expected to follow instructions, procedures and to elevate any issue impacting workflow, quality, etc.
• Employees must exhibit honesty and integrity as well as demonstrate adherence to rules, procedures and policies.

Skills

Schematic reading

SolidWorks

Altium/Mentor

Communication

Analytical thinking

Electrical testing

SAP ERP

Induction motors

AC servo motors

Travel 0-5%

Education

Bachelor's degree in Electrical Engineering

0-2 years experience

Tools

SolidWorks routing

Mentor Graphics

Altium

Microsoft Office

TEAMS

SAP ERP

Job description

Haas Automation in Oxnard, CA is seeking an Electrical Engineer 1 to integrate, test, and maintain electrical systems for CNC control units, under supervision. You will design cabling, write ECOs, manage configurations, and sustain production activities on-site.

Relocation to Henderson, NV by February 2027 is required. Travel 0–5% and strong skills in SolidWorks, Altium/Mentor Graphics, and testing hardware are preferred.