DRILLING OPERATOR - Third Shift Overnights

American Standard Circuits; West Chicago (IL); On-site; USD 21,000 - 30,000; Full time

Job summary

American Standard Circuits is seeking a manufacturing operator to support drilling and routing of panel boards on the 3rd shift. You will position panels, verify tooling, and perform quality checks against templates.

The role requires a high school diploma, good manual dexterity, and the ability to work standing for long periods in a noisy, manufacturing environment. Training may occur on 1st or 2nd shift during initial weeks.

Qualifications

• High school diploma is required.
• Experience operating drilling/routing machines is beneficial.
• Ability to read and follow templates and specs.

Responsibilities

• Position panels on machine table and align with tooling holes.
• Check processed parts against template.
• Check tool sizes and replace/reset tools as needed.
• Notify supervisor of equipment or operating difficulties.

Skills

Manual dexterity

Templates reading

Education

High school diploma

Tools

Drill press

Job description

Description

3rd Shift runs from 10:30 p.m. - 7:00 a.m., Monday - Friday. Overtime will often be available during the week. Training may take place on 1st or 2nd shift for the first 4 - 6 weeks.

SUMMARY OF FUNCTIONS

Actively involved in all duties for procedures related to operate machines to drill and/or rout panel boards.

ESSENTIAL DUTIES AND RESPONSIBILITIES

• Position panels on machine table, flush and aligned with tooling holes, start operation and remove boards at the end of the cycle.
• Check processed parts against template.
• Check tool sizes, remove and replace reset tools in magazine. Replace broken tools as required.
• Obtain and put away drills, mark drills that need to be re-sharpened.
• Notify supervisor of unusual equipment or operating difficulties.

Requirements

QUALIFICATIONS

A high school diploma is required.

PHYSICAL DEMANDS

Standing for long periods of time is required.

Exertion of up to 50 lbs. of force occasionally may be required. Good manual dexterity for the use of common office equipment such as computer terminals, calculator, copiers, and FAX machines.

Use of small drill bits; dexterity required.

WORK ENVIRONMENT

This position is in a manufacturing setting with exposure to noise, dirt and chemicals.

WORK SCHEDULE

Training may take place on one of three shift for the first 4 - 6 weeks based on performance:

1st shift training: 7:00 a.m. - 3:30 p.m.

Mid shift training: 11:00 a.m. - 7:30 p.m.

2nd shift training: 3:15 p.m. - 11:45 p.m.

Permanent schedule would be 10:30 p.m. - 7:00 a.m., Monday - Friday with some overtime available during the week.