Analog IC Design Engineer

Texas Instruments; Texas; Presencial; USD 130 000 - 190 000; Tempo integral

Resumo da oferta

Texas Instruments invites a lead IC Design Engineer to join the RF Transceiver Group in Connectivity. You will drive design cycles for RF blocks, including PLL, IF filters, VGA, and Transmitter/ADC paths, and guide the team from architecture to tapeout with test and validation through handover to the modem.

The role emphasizes analog RF expertise, layout-sense design, and a holistic view of radio silicon, packaging, and PCB integration within TI’s Wireless/Connectivity portfolio.

Qualificações

• Must have completed at least one full RF transceiver design cycle (architecture through tapeout).
• Experience with PLL/clock systems, DAC/ADC paths, and RF blocks.
• Strong layout-aware design with verification and test experience.

Responsabilidades

• Lead design cycles for RF transceiver blocks (PLL, IF filters, VGA).
• Oversee schematic, layout, extraction, and test of RF ICs.
• Collaborate cross-functionally to meet system and product targets.

Conhecimentos

RF IC Design

Analog RF

Schematic/Layout

Test & Verification

Leadership

Formação académica

Bachelor's in EE or related field

MS preferred

Ferramentas

Cadence

LTSpice

Descrição da oferta de emprego

About RF Transceiver Group in Connectivity:

Texas Instruments RF Connectivity group is expanding their RF Transceiver Design group. This group develops cutting edge RF Transceiver products (+MCU integrated) for Wireless-LAN (WIFI) and Ultra-Wideband Systems (UWB). The candidate will join in the UWB Design group. Candidate gets to experience Block Architecture Phase, Concept Design and take the design through the various design phases such as Schematic, Layout, Extracted simulations and Test and Verification. The role is primarily in Analog/RF class of circuit design to meet the overall System & Product requirements. The typical blocks include RF blocks such as LNA, TA, Down-conversion Mixers, Base-band filters, High Speed ADC to send data to the Modem. Reverse Chain namely for Transmitter, starting from DAC, Base-band filter, Up-conversion mixer and Power Amplifier stages to drive the TX Pin. LO system design including Chrystal Oscillator, integer/fractional PLL and LO Distribution systems. Various Calibration modules (AGC, PDET, Gain, Offset, IQMM, etc) to calibrate the Transceiver chain is part of the design. Low Current Mode and Complex Power Management to operate at low LDO input voltage etc. The Design Engineer in RF Connectivity gets introduced to a Holistic view of the product including, Radio Silicon Design, Packaging and PCB and solution design.

About the Role:

We are hiring one lead level IC Design Engineer with demonstrated design cycle experience. Some of the possible roles are:

1. PLL & Clock System Design
2. IF filter and VGA Design
3. Transmitter Design
4. ADC Design

Candidate should have gone through 1 complete design cycle of an RF transceiver: namely Architecture, Schematic Design, Layout Design, Tape Out, Test & Validation and identifying design fixes for subsequent Tape Out.