Aerospace Composite Fabrication Technician II

Advanced Composite Products & Technology Inc; Santa Ana (CA); On-site; USD 70,000 - 95,000; Full time

Job summary

Advanced Composite Products & Technology Inc. in Santa Ana, CA seeks a hands-on Composite Fabrication & Integration Technician II to perform layup, bagging, curing, bonding, and assembly of large aerospace structures.

You will work from approved work instructions, fabricate to tight tolerances, and support I-level personnel while maintaining AS9100 quality standards. Responsibilities include reading drawings, setting up Gerber cutting, prepping materials, curing cycles, demolding, finishing,

Qualifications

• Read and interpret engineering blueprints, drawings, and ply layup schedules.
• Follow written work instructions in English and maintain accurate documentation.
• Operate with independent judgment under released planning and escalate when needed.
• Maintain high attention to detail across multi-ply layups and tooling.

Responsibilities

• Read work instructions, shop travelers, blueprints, and layup schedules.
• Prepare, lay up, and vacuum bag prepreg materials to spec and orientation.
• Operate Gerber cutting system, verify material placement and cut quality.
• Load/unload autoclave/oven cures, monitor cycles, and document results.
• Demold, trim, finish, bond assemblies, and support quality inspections.
• Provide training and direction to Technician I personnel as needed.

Skills

Blueprint reading

Attention to detail

Independent judgment

English instruction comprehension

Hand dexterity

Organizational skills

Education

High school diploma or equivalent

Tools

Gerber cutting system

Autoclave

Oven

Laser ply projection systems

Overhead crane

Job description

Advanced Composite Products & Technology Inc. in Santa Ana, CA seeks a hands-on Composite Fabrication & Integration Technician II to perform layup, bagging, curing, bonding, and assembly of large aerospace structures.

You will work from approved work instructions, fabricate to tight tolerances, and support I-level personnel while maintaining AS9100 quality standards. Responsibilities include reading drawings, setting up Gerber cutting, prepping materials, curing cycles, demolding, finishing,