Process Development Engineer - Photolithography

Process Development Engineer - Photolithography

Job Responsibilities :

• Supervise / support Wafer Fab manufacturing areas, working in a clean room environment.
• Main focus on photolithography, supporting Stepper and track processes, including introduction and qualification of new reticles and recipes.
• Develop new industrial processes and maintain / improve existing ones.
• Collaborate and provide technical advice to R&D and manufacturing teams to guarantee product quality, product cost, and manufacturing efficiency.
• Support development of thin film vacuum deposition processes, dry and plasma etching.
• Investigate and perform troubleshooting analysis on possible process / product problems.
• Liaise with installation / maintenance team and specialists for equipment upgrade and calibration.
• Work with EHS representative to ensure safe working conditions and compliance with health and safety legislation.
• Setup Statistical Process Control approach to improve yield and rework rate.
• Introduce technological innovation to increase yield and reduce process lead time.
• Responsible for process documentation and work instructions necessary for transferring new processes to manufacturing.
• Control new product introduction from design into manufacturing.
• Perform manufacturing operators' training.

Job Requirements :

• Bachelor's or Master's degree in an Engineering discipline (Electronic, Material), Physics, or Chemistry.
• Experience in wafer fab processes and manufacturing (nanotechnologies or semiconductor industry).
• Hands-on experience with Overlay and CDSEM metrology preferred.
• Knowledge of plasma etching techniques is a plus.
• Experience in Chemical Vapor Deposition (CVD) is a plus.
• Experience in Chemical Mechanical Polishing (CMP) is a plus.
• Good attitude towards teamwork and proactive interaction with all functions and levels.
• Fluent in English (spoken and written).
• Availability to travel.
• Knowledge of process validation procedures and techniques, e.g., process and product FMEA, basic six sigma concepts like capability studies and SPC is a plus.
• Competent with Microsoft Office applications and statistical tools (LabView knowledge is a plus).

J-18808-Ljbffr