Senior Injection Molding Process Engineer

Agensi Pekerjaan Minde Group Sdn Bhd; Johor Bahru; On-site; MYR 60,000 - 90,000; Full time

Job summary

Agensi Pekerjaan Minde Group Sdn Bhd is seeking a Manufacturing Engineer (Injection Molding Process) in Malaysia. The candidate will optimize molding processes, work with tooling and maintenance teams, and drive defect reduction through robust quality controls.

A bachelor’s degree in a related engineering field and 3–5 years of experience are required. Qualifications include knowledge of materials processing and ISO/compliance practices.

Qualifications

• Bachelor's degree in Manufacturing/Mechanical/Plastics Engineering.
• 3–5 years of experience in injection molding process engineering.
• Experience in high-volume manufacturing preferred.

Responsibilities

• Injection Molding Process Optimization: Develop, improve, and troubleshoot injection molding processes to enhance production efficiency and product quality.
• Tooling & Equipment Management: Work closely with toolmakers and maintenance teams to ensure molds and injection machines are operating at peak performance.
• Quality Control & Defect Reduction: Implement and monitor quality control measures to minimize defects such as flash, warpage, and short shots.
• Material Selection & Processing: Evaluate raw materials (plastics, resins) and ensure the correct processing parameters for each.
• Continuous Improvement: Lead process improvement initiatives (Lean, Six Sigma) to optimize cycle times, reduce scrap, and increase productivity.
• Technical Support & Troubleshooting: Diagnose molding defects and provide solutions to production teams.
• Documentation & Compliance: Maintain process documentation, work instructions, and ensure compliance with ISO standards and safety regulations.

Skills

Injection molding

Process optimization

Quality control

Troubleshooting

Education

Bachelor's in Manufacturing Engineering

Bachelor's in Mechanical Engineering

Bachelor's in Plastics Engineering

Job description

Agensi Pekerjaan Minde Group Sdn Bhd is seeking a Manufacturing Engineer (Injection Molding Process) in Malaysia. The candidate will optimize molding processes, work with tooling and maintenance teams, and drive defect reduction through robust quality controls.

A bachelor’s degree in a related engineering field and 3–5 years of experience are required. Qualifications include knowledge of materials processing and ISO/compliance practices.