Metrology Specialist

Blu Comet Precision Sdn Bhd; Simpang Ampat; On-site; MYR 33,000 - 67,000; Full time

Job summary

Blu Comet Precision Sdn Bhd is seeking a QC Inspector to perform dimensional inspection of components using CMM and VMM in Penang, Malaysia. You will handle precision measuring tools and ensure conformance to engineering drawings and GD&T requirements.

Responsibilities include FAI, in-process and final inspections, preparation of detailed inspection reports, NCR initiation, and CAPA activities, with collaboration across Production and Engineering to drive root-cause solutions.

Qualifications

• Ability to read engineering drawings and interpret tolerances and GD&T.
• Conduct FAI, in-process, final and incoming inspections.
• Prepare and maintain inspection reports, records, and traceability documents.
• Identify non-conforming products, raise NCRs, and support containment and corrective actions.
• Collaborate with Production and Engineering to root-cause quality issues.
• Ensure measuring equipment is calibrated and within validity.
• Follow SOPs and sampling plans, maintain 5S and proper equipment handling.

Responsibilities

• Perform dimensional inspection of incoming, in-process, and finished components using CMM and VMM.
• Operate common QC measuring instruments such as calipers, micrometers, height gauges, bore gauges, and projectors.
• Interpret drawings, tolerances, GD&T, specifications, and inspection criteria.
• Conduct FAI, in-process, final, and incoming inspections.
• Prepare inspection reports, measurement records, and quality check sheets.
• Identify non-conforming products, raise NCRs, and support containment and corrective actions.
• Investigate dimensional or quality issues with Production and Engineering to determine root causes.
• Ensure measuring equipment is calibrated and within calibration validity before use.
• Monitor product quality and verify compliance with customer requirements and approved drawings.

Skills

CMM

VMM

Vernier calipers

Micrometers

Height gauges

Bore gauges

Profile projectors

GD&T

Inspection reports

NCRs

Tools

Surface plates

Profile projectors

Height gauges

Bore gauges

Gauge pins

Job description

Perform dimensional inspection of incoming, in-process, and finished components using CMM (Coordinate Measuring Machine) and VMM (Vision Measuring Machine).

Operate common QC measuring instruments such as Vernier calipers, micrometers, height gauges, bore gauges, pin gauges, thread gauges, surface plates, and profile projectors.

Interpret engineering drawings, dimensional tolerances, GD&T, specifications, and inspection criteria.

Conduct first article inspection (FAI), in-process inspection, final inspection, and incoming inspection.

Prepare and maintain inspection reports, measurement records, quality check sheets, and traceability documents.

Identify non-conforming products, raise NCRs, and support containment and corrective-action activities.

Work with Production and Engineering teams to investigate dimensional or quality issues and determine root causes.

Ensure measuring equipment is properly calibrated, maintained, and within calibration validity before use.

Monitor product quality and verify compliance with customer requirements, internal standards, and approved drawings/specifications.

Support CAPA, 8D, root-cause analysis, 5 Why, and basic quality-improvement activities.

Follow established SOPs, inspection procedures, sampling plans, and quality-control standards.

Maintain good 5S and proper handling/storage of measuring and inspection equipment.