Prototype Wirer

Mane Contract Services; Rugby; On-site; GBP 23,000 - 27,000; Full time

Job summary

Mane Contract Services is seeking an experienced electrical assembler to support prototype development on site. You will wire prototypes, build and assemble units, read diagrams and use a range of hand and power tools to complete assembly tasks.

Hours are Monday to Thursday 8.30am–5.30pm and Friday 8.30am–1.00pm, with on-site work on production floor. The role requires careful fault finding, soldering and adherence to safety standards. Occasional overtime may apply.

Qualifications

• Must have good soldering & wiring skills.
• Ability to read and interpret electrical wiring diagrams and assembly drawings.
• Proficient in using a range of hand tools and power tools.
• Experience with electrical test equipment and measurements.

Responsibilities

• Prototype wiring in accordance with regulations and electrical & mechanical drawings/work to samples.
• Install, test, commission, maintain and build electrical systems and components.
• Prototype wiring and building of prototype units.
• Perform point to point wiring, cable crimping, looming & terminating work.
• Locate and repair faults in electrical power supply equipment.
• Carry out mechanical fitting and relevant assembly work.
• Read and interpret wiring diagrams and assembly drawings.
• Use a variety of hand tools and electric power tools.

Skills

Soldering

Wiring skills

Reading diagrams

Hand tools usage

Electrical testing

Tools

Power tools

Test equipment

Measuring instruments

Crimp tools

Job description

Key responsibilities and accountabilities:

Prototype Wiring in accordance with regulations and electrical & mechanical engineering drawings/work to samples. Install, test, commission, maintain and build electrical systems and components.

Electrical Assembly:

• Prototype wiring
• Building & assembling of prototype units
• Point to point wiring, cable crimping, looming & terminating work
• Correctly use and maintain the tools of the trade including power tools, test equipment and measuring instruments.
• Locate and repair faults in electrical power supply equipment.
• Must have good soldering & wiring skills
• Carry out mechanical fitting and relevant assembly work.
• Read and interpret electrical wiring and circuit diagrams, and assembly drawings.
• Must be able to use variety of hand tools such as crimp tools, wire strippers, spanners, screw drivers, ratchet sets as well as electric power tools.

Hours of work: Monday to Thursday 8.30am to 5.30pm. Fridays 8.30am to 1.00pm.

Interview Process:

• 1st stage is a Teams Interview with HR.
• 2nd stage is an onsite interview with HR & CEO. Then after that, an introduction to the production Supervisor.

H&S:

Must wear safety shoes at times whilst working on the shop floor