Tile Cutting Sew On Operator

Engineered Floors, LLC; Dalton (GA); On-site; USD 20,664 - 27,552; Full time

Job summary

Engineered Floors, LLC in Dalton, GA seeks a Tile Cutting Sew On Operator to sew rolls according to schedule and manage associated data entry. You will start with scanning rolls, ensuring correct seams, trimming ends, and maintaining alignment to keep tension proper.

The role emphasizes safety, the ability to lift light weights, and attention to accuracy in recording yards and roll numbers as part of daily production tasks.

Qualifications

• Must be able to read and write and do basic arithmetic.
• Computer knowledge or data entry skills are a necessary part of the job.

Responsibilities

• Sew rolls together with straight seams and trimmed ends.
• Record roll numbers, yards, and other data for each roll processed.
• Maintain clean and safe work area and report quality or safety issues.

Skills

Reading and writing

Basic math

Data entry

Education

High school diploma or equivalent

Tools

Scissors

Wrenches

Job description

Job Summary

The Tile Cutting Sew On Operator is responsible to sew on rolls according to schedule.

Essential Duties & Responsibilities

• Scan roll number on each roll.
• Record roll numbers, yards, etc. of each roll sent through the coater.
• Sew rolls together. Be sure seams are straight, tightly sewn and ends trimmed as little as possible.
• Responsible for correct rolls to be sewn. Attach "style flags" to first roll of each run.
• Start accumulator and run the correct amount of carpet from the roll into the accumulator. Care should be taken to keep the carpet aligned properly to keep tension adjusted.
• Keep work area clean.

Performance Expectations (if applicable)

• Lifting is required of cores, and buckets weighing 30 lbs approximately 80 times per shift.
• Standing is required 80% of the shift.
• Reaching is required for cores 40 to 100 times per shift.
• Stooping is required 15 to 30 times per shift for intervals of 1 to 2 minutes.
• Bending is required for cores 25 to 30 times per shift.
• Must be able to use scissors.
• Must be able to use wrenches.

Experience/Education Requirements

• High school diploma or equivalent preferred.
• Must be able to read and write and do basic addition, subtraction, division, and multiplication.
• Computer knowledge or data entry skills are a necessary part of the job.

Other Requirements

• Overtime is required on occasion.
• All accidents must be reported immediately.
• Perform any other duties as assigned.
• Safety equipment must be worn as required and requirements must be followed for all areas.
• Report to management any quality, safety, or potential problems encountered while performing the job.
• Responsible for quality and safety of his/her own output.