RF Verification & Qualification Test Engineer

Lockheed Martin Corporation; Grand Prairie (TX); Sur place; USD 71 000 - 131 000; Plein temps

Avantages offerts par ce poste

Medical, Dental, Vision

Flexible work arrangements

401(k) match

Résumé du poste

Lockheed Martin is seeking a Design Verification & Qualification Test Engineer (DVT) at Grand Prairie, TX to plan and execute design verification and qualification tests for RF sensor hardware.

You will develop test procedures, run laboratory tests, analyze results, and document findings, applying MIL-STD-810/EMI concepts and ensuring compliance with safety and quality standards. This role requires a bachelor’s in a STEM field, hands-on RF experience, and US citizenship.

Qualifications

• Bachelor's degree in Electrical, Electronics, Systems Engineering, Physics, or a related STEM field, or equivalent combination of relevant education and experience.
• 1+ years of related experience in hardware testing, design verification, qualification testing, or RF laboratory work.
• Hands-on experience with RF laboratory equipment and electronic measurement techniques.
• Knowledge of environmental test practices, including MIL-STD-810, and EMI/EMC test concepts.
• Ability to follow and develop test procedures, analyze measurement data, and document results clearly.
• Ability to solve moderately complex test problems using established methods and work effectively with periodic technical review.
• Interim security clearance is required to start, therefore you must be a US Citizen.

Responsabilités

• Development of test plans and procedures using established requirements, methods, and acceptance criteria.
• Configure RF instrumentation, test fixtures, data acquisition, and test articles in accordance with approved procedures and safety requirements.
• Execute RF performance tests, record test conditions and as-run configurations, and maintain accurate laboratory records.
• Support environmental testing using MIL-STD-810 methods and EMI testing using program-specified standards.
• Check instrumentation calibration status and perform setup checks before collecting data.
• Analyze test data, compare results with acceptance criteria, and prepare test reports for review.
• Troubleshoot test setup and measurement issues of moderate complexity; elevate unexpected hardware behavior.
• Work with design, systems, and laboratory personnel to document anomalies, support corrective actions, and perform retests.
• Maintain test records and configuration information and contribute improvements to procedures and data-processing tools.

Connaissances

RF testing

Laboratory work

Test procedures

Data analysis

Team collaboration

Formation

Bachelor's degree in Electrical/Electronics/Systems Engineering or related STEM

Outils

MATLAB

Python

LabVIEW

Signal generators

Spectrum analyzers

Network analyzers

RF power measurements

Description du poste

Lockheed Martin is seeking a Design Verification & Qualification Test Engineer (DVT) at Grand Prairie, TX to plan and execute design verification and qualification tests for RF sensor hardware.

You will develop test procedures, run laboratory tests, analyze results, and document findings, applying MIL-STD-810/EMI concepts and ensuring compliance with safety and quality standards. This role requires a bachelor’s in a STEM field, hands-on RF experience, and US citizenship.