Quality Inspector

Paycom - ATS; Minneapolis (MN); On-site; USD 42,000 - 62,000; Full time

Job summary

Paycom - ATS seeks a detail-oriented Quality Inspector to visually and dimensionally assess received, in-process, and finished components, document results, and prepare customer quality documentation. You will coordinate shipment and support safety culture.

You will use micrometers, calipers, optical comparators, gauge pins and scales following Inspection Plans, perform incoming/in-process/final sampling, and log results in the IQ system; ensure non-conforming material is dispositioned per SOPs.

Qualifications

• High school diploma or GED; or 3–6 months related experience and/or training plus coursework in inspection and gauging, blueprint reading, SPC and GD&T.
• Strong knowledge of inspection plans and gauging techniques.
• Familiarity with micrometers, calipers, optical comparators, and related measuring tools.

Responsibilities

• Inspect parts visually and dimensionally using micrometer, microscope, optical comparator, gauge pins, caliper, height indicator and scales according to Inspection Plans.
• Perform incoming material sampling inspections according to specified plans.
• Verify supplier documentation meets incoming materials requirements.
• Perform in-process sampling per inspection procedures and document results.
• Perform final sampling per inspection procedures and document results.
• Prepare final shipment, source inspection and documentation.
• Perform lot transactions using the IQ system.
• Follow procedures for documentation and disposition of non-conforming material.
• Ensure readiness of lots for source inspection and assist source inspectors as required.
• Communicate inspection results clearly and document results legibly.
• Follow applicable standard operating procedures.

Skills

Blueprint reading

Inspection and gauging procedures

Dimensional inspection

Geometric dimensioning and tolerancing

Education

High school diploma or GED

Course work in inspection and gauging, blueprint reading, SPC and GD&T

Tools

Micrometer

Caliper

Optical comparator

Height indicator

Gauge pins

Job description

SUMMARY: Inspect parts visually and dimensionally, document inspection results and enter data.KEY ACCOUNTABILITIES:Perform visual and dimensional inspections of received components, in-process components, reworked, and finished goods and accurately enter the resulting data.Prepare customer quality documentation as required.Coordinate shipment of finished product.Actively promote and drive a culture of safety.KEY RESPONSIBILITIES:Inspect parts both visually and dimensionally using micrometer, microscope, optical comparator, gauge pins, caliper, height indicator and scales according to the instructions in the Inspection Plans.Perform incoming material sampling inspections according to specified plans.Verify documentation provided by supplier meets the requirements for incoming materials.Perform in-process sampling per inspection procedures and document results.Perform final sampling per inspection procedures and document results.Prepare final shipment, source inspection and documentation.Perform lot transactions using the IQ system.Follow procedures for documentation and disposition of non-conforming material.Ensure readiness of lots for source inspection and assist source inspectors as required.Communicate clearly and document inspection results legibly.Follow applicable standard operating procedures.Other duties as assigned.EXPERIENCE, SKILLS, EDUCATION AND TRAINING:High school diploma or general education degree (GED); or three to six months related experience and/or training plus course work in inspection and gauging, blueprint reading, SPC and geometric dimensioning and tolerancing.WORK ENVIRONMENT AND PHYSICAL DEMANDS:The employee must occasionally lift and/or move up to 25 pounds. The noise level in the work environment is quiet/moderate in inspection and loud on the production floor.