Lead Electrical & Controls Engineer

My Hr; Sandy Plains (GA); Sur place; USD 120 000 - 180 000; Plein temps

Résumé du poste

My Hr in Sandy Plains, GA is seeking a Lead Electrical & Controls Systems Engineer who takes ownership from incoming power to the last sensor signal. You will design panels, write PLC logic, and work closely with the assembly team to bring the system to life.

You will lead the electrical and controls stack for modular skids and containerized treatment systems, set technical direction, develop drawings and interconnections, and establish standards for build, test, and service.

Qualifications

• Electrical & Panel Design experience with 480V, 120/208V, and 24VDC systems.
• Hands-on PLC programming and structured, maintainable control logic.
• Siemens experience is preferred; Beckhoff or comparable platforms are valuable.
• Industrial communications familiarity with OPC UA, PROFINET, EtherNet/IP.
• System integration & wiring: cable routing, power and signal segregation, labeling.
• Technical & supplier ownership: independently own electrical & controls design and work with suppliers.

Responsabilités

• Designing electrical and controls architecture for modular skids and containerized treatment systems.
• Developing control panels, electrical drawings, PLC programs, and system interconnections.
• Working with suppliers and our engineering team to turn designs into clean, repeatable products.
• Establishing standards that make systems easier to build, test, commission, and service.

Connaissances

Industrial automation

Power distribution

Electrical design

PLC programming

HMI design

Outils

Siemens equipment

Beckhoff controllers

Description du poste

My Hr in Sandy Plains, GA is seeking a Lead Electrical & Controls Systems Engineer who takes ownership from incoming power to the last sensor signal. You will design panels, write PLC logic, and work closely with the assembly team to bring the system to life.

You will lead the electrical and controls stack for modular skids and containerized treatment systems, set technical direction, develop drawings and interconnections, and establish standards for build, test, and service.