Fabrication Operator - 1st Shift (Welding & Inspection)

Southern CaseArts; Jasper (GA); On-site; USD 21,000 - 28,000; Full time

Job summary

Southern CaseArts is seeking an Operator for Production Cell A on the 1st shift in Jasper, GA. The role is a full-time, hourly position with early start hours (6:00 am–4:30 pm) and occasional Saturdays. Responsibilities include part measurement, inspection, setup, and basic welding support.

The candidate should have basic troubleshooting, math skills, and the ability to read drawings. Proactive, safety-conscious individuals who can adapt to change are preferred.

Qualifications

• Basic machine troubleshooting ability.
• Solid math skills and the ability to perform calculations.
• Ability to read and interpret drawings, sketches, and dimension diagrams.
• Ability to measure physical parts with gauges such as calipers or scales.
• Good mechanical aptitude and practical understanding of tooling.
• Ability to understand the tooling, components, and capability of the machine.
• Working knowledge of bend allowances for different materials.
• Ability to understand programming requirements and modify programs.

Responsibilities

• Measure parts for accuracy and inspect for defects against drawings.
• Keep the work area clean and support 5S activities.
• Observe safety regulations and report issues.
• Set up machines, modify programs, and adjust finger tooling as needed.
• Meet set-up times and production rates.
• Unload products from equipment and place them correctly.
• Complete daily production on time.
• Perform spot welding and MIG welding as required.
• Demonstrate adaptability to change and learn new skills.
• Support lean production activities and other duties as assigned.

Skills

Basic machine troubleshooting

Math skills

Reading drawings

Measuring with gauges

Mechanical ability

Tooling knowledge

Bend allowances

Programming understanding

Job description

Southern CaseArts is seeking an Operator for Production Cell A on the 1st shift in Jasper, GA. The role is a full-time, hourly position with early start hours (6:00 am–4:30 pm) and occasional Saturdays. Responsibilities include part measurement, inspection, setup, and basic welding support.

The candidate should have basic troubleshooting, math skills, and the ability to read drawings. Proactive, safety-conscious individuals who can adapt to change are preferred.