Electrician Apprentice: Hands-On Wiring & System Startups

TIC - The Industrial Company; Harrah (OK); On-site; USD 52,000 - 76,000; Full time

Job summary

TIC - The Industrial Company is seeking an experienced electrical technician to plan, lay out, install and repair wiring and control systems in accordance with plans, codes and industry standards.

The role requires interpreting drawings, installing conduit, testing systems, and ensuring safety of components in both high and low voltage environments. Physical work, outdoors, and potential overtime are expected.

Qualifications

• High school diploma or equivalent with relevant experience.
• Must possess working knowledge and abilities for position.
• Ability to understand, follow and transmit written and oral instructions and communicate effectively.
• Ability to use hand tools, power tools and layout tools safely and efficiently.

Responsibilities

• Interpret sketches, drawings, software and plans to determine best procedures, tools and equipment for troubleshooting and repair.
• Measure, cut, bend, thread, assemble and install electrical conduit; weld supports; install cable and duct banks; make terminations.
• Install control and distribution apparatus and fasten in place.
• Test and start up systems and verify circuit continuity for electrical compatibility and safety.
• Observe functioning of installed equipment to determine hazards and needed adjustments, relocation or replacement.
• May pull wire through conduit and connect wiring to lighting fixtures and power equipment.
• Work with high and low voltage systems.
• Disassemble and repair defective electrical equipment or systems.
• Operate electrical and mechanical hand tools, power tools, hydraulic and pneumatic tools.

Skills

Reading drawings

Troubleshooting

Conduit installation

Electrical wiring

Testing systems

Education

High school diploma or equivalent

Tools

Hand tools

Power tools

Layout tools

Job description

TIC - The Industrial Company is seeking an experienced electrical technician to plan, lay out, install and repair wiring and control systems in accordance with plans, codes and industry standards.

The role requires interpreting drawings, installing conduit, testing systems, and ensuring safety of components in both high and low voltage environments. Physical work, outdoors, and potential overtime are expected.