CNC Operator

G3 Industries | Sussex; Sussex (WI); Sur place; USD 38 000 - 46 000; Plein temps

Résumé du poste

G3 Industries | Sussex in Wisconsin is seeking a Quality Technician to perform precise quality checks with gauges and visual inspection during production, ensuring adherence to schedules and safety policies. The role demands the ability to read travelers and job routings, operate various machines safely, and maintain clean, organized work areas.

You will read blueprints, report labor, rework and scrap in the computer system, and participate in operator maintenance as needed.

Qualifications

• CNC experience preferred.
• Must be able to read and understand basic blueprints.
• Familiarity with GD&T symbols is an asset.
• Basic computer skills and knowledge are required.
• Candidates should show attention to detail and follow safety procedures.
• Must be able to stand for 8 hours and lift up to 10 lbs as needed.

Responsabilités

• Perform quality checks with gauges and visual inspection during production.
• Run production according to schedules and assist as needed.
• Read travelers and job routings and interpret basic blueprints.
• Report labor, rework, and scrap in the computer system.
• Perform operator maintenance on the machine when required.
• Maintain a clean and safe work area and follow safety procedures.

Connaissances

CNC experience

Read blueprints

GD&T symbols

Basic computer skills

Attention to detail

Safety procedures

Stand 8 hours

Lift up to 10lbs

Description du poste

**Principle Duties and Areas of Responsibility:**Must perform Quality Checks with the use of gauges and visual inspection during specified time periods while running production.Must run production according to schedules, unless instructed otherwise.Demonstrate ability to safely operate various machines.Must be able to read and understand Travelers / Job routings.Read and understand basic blueprints.Report labor, rework, and scrap directly in computer operating system.Perform or identify with any operator maintenance on the machine in use.Perform repetitious tasks, occasionally subject to frequent changes in job assignment as requested by Department Lead.Other tasks as needed.**Skills and Abilities:**CNC experience preferred.Must be able to lift up to 10lbs continuously.Must be able to stand for 8 hours a dayMust be self-motivatedBasic computer skills and knowledge.Must keep machine and area cleanUnderstand ± tolerances and limitsRecognize basic GD&T symbolsFollows safety proceduresShows up consistently / good attendancePays attention to detail.| || |**Physical Requirements:**Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions. Use these codes to complete this section: \"F\" for frequently; \"O\" for occasionally; \"N\" for not at all.Physical ActivityOn the job the employee must:(F) Bend (N) Sit(F) Squat (F) Stand(N) Crawl (F) Walk(O) Climb (F) Push/Pull(F) Kneel(F) Handle objects (manual dexterity)(F) Reach above shoulder level(F) Use fine finger movements(F) Repetitive movement() OtherMust carry/lift loads of:(O) Light (up to 25lbs.)(O) Moderate (25-50lbs.)(N) Heavy (over 50lbs.)Physical ExposureOn the job the employee:(F) Is exposed to moderate or excessive (circle) noise(F) Is around moving machinery(F) Is exposed to marked changes in temperature and/or humidity(F) Is exposed to dust, fumes, gases, microwave, Other(circle)(N) Drives motorized equipment(N) Works in confined quarters(N) Unprotected heights() OtherPhysical Ability: Acceptable MinimumVision: () Good () Poor () BlindColor Vision: () Normal () ImpairedHearing: () Normal () Moderate Loss () DeafTalking/Speech: () Good () Fair () Mute| || |