CMM Operator

H M DUNN COMPANY INC; Wichita (KS); On-site; USD 55,000 - 75,000; Full time

Job summary

H M DUNN COMPANY INC in Wichita, KS seeks a CMM programmer/operator to develop and execute programs for coordinate measuring machines, verify part configurations against drawings and customer specs, and document results.

You will review planning, create programs with PC-DMIS, operate CMM with DCC controls, and support continuous improvement while meeting deadlines; occasional travel may be required.

Qualifications

• Experience with PC-DMIS or similar CMM programming software.
• Ability to read blueprints and GD&T drawings accurately.
• Proficiency in shop math and interpreting customer standards.

Responsibilities

• Write and run CMM programs to verify part dimensions.
• Position and level parts on surface plate for measurement.
• Activate measuring equipment and record key tolerances.
• Compare measurements to drawings and document discrepancies.
• Prepare and deliver reports on non-conformances.
• Support continuous improvement initiatives and teamwork.

Skills

PC DMIS

CMM programming

GD&T

Blueprint reading

Shop math

AS9100 familiarity

DCC controls

Time management

Communication

Tools

DCC controls

CMM equipment

Job description

Summary:This position is responsible for writing programs for and operating a Coordinate Measuring Machine (CMM) to verify that the configuration of manufacture parts meets the customer’s requirements.This position has no supervisory responsibilities.Essential Duties and Responsibilities:Review planning, engineering drawings, and digital models to determine proper dimensions and tolerance specifications for specific parts and/or tools to be measuredStart equipment and select program from the available listings, match part/tool identification with computer program, and perform set up operationsPosition and level part / tool on surface plate of CMM taking care not to damage part / tool or the machineActivate digital readout equipment and record specified measurementsCompare measurements to specified dimensions and tolerances noting discrepanciesPerform manual dimensional check as needed to verify questionable resultsDocument all non-conforming conditionsAnalyze data, prepare, and deliver reportsIdentify and participate in continuous improvement projectsCommunicate effectively (verbal and written) with all contactsAccept and adapt easily to changeEnsure that all activities are consistent with Company Mission StatementOperate job-related equipment with or without an accommodationMeet physical demands of job with or without an accommodationPerform other duties as assignedRequirements:To perform this job successfully, an individual must be able to perform each essential function and assigned task satisfactorily. The requirements listed below are representative of the knowledge, skills, competency, and/or abilities required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.Experience with recent version of PC DMIS requiredExperience creating CMM programs desiredExperience operating CMM with DCC controls requiredFamiliarity with AS9100Proficient reading blueprints, using shop math, and GD&T requiredAbility to read, interpret, and apply customer defined standards and specificationsExhibits dependability, including following instructions; responding to supervisor’s direction; and taking responsibility for own actionsAbility to take initiative, including asking for and offering help when needed, and perform work independently without being promptedAbility to manage competing priorities, prioritize and plan work activities, use time efficiently, and work within deadlinesWell-developed presentation preparation and delivery skillsFlexibility to work evenings or weekends and travel as needed (less than 10% of time)U.S. Citizen or Permanent Resident (ITAR requirement)Acceptable attendancePositive attitudeTeam playerSense of urgencyAbility to meet frequent short timeline goals and deadlines