Advanced Circuit Board Test Technician

Jabil; Florence (KY); On-site; USD 34,000 - 52,000; Full time

Job summary

Jabil in Florence, KY is seeking a Test Technician to set up and run equipment for programming and verification tests on circuit boards. You will ensure quality, operate various test instruments, and support production flow on the manufacturing line.

Applicants should have a high school diploma and prior tester experience; certification may be required. This is an on-site role with emphasis on safety and accuracy.

Qualifications

• High school degree or equivalent preferred; and one year of experience in a Jabil Tester position; or equivalent combination of education and experience.
• Must be able to obtain and maintain all required job related certifications.

Responsibilities

• Set-up equipment to perform required programming and verification tests following established procedures.
• Ensure quality and improve efficiency using the CIQ system where available.
• Operate automated and manual electronic test equipment on circuit board assemblies and subassemblies.
• Properly load and unload test fixtures.
• Handle product without compromising equipment or personnel safety.
• Use test measurement devices such as DVMM, oscilloscope, frequency counter, etc. to perform tests.
• Maintain continuous flow of the manufacturing line and meet production goals while performing test duties.
• Label, stamp or mark boards and fill out tags; use barcode scanner.
• Assist Tester I and Tester II personnel as needed.
• Report recurring test failures to supervisor for corrective action.

Skills

Test equipment operation

Quality control

Laser safety training

CIQ system

Education

High school diploma

Tools

Bar-code scanner

Job description

Jabil in Florence, KY is seeking a Test Technician to set up and run equipment for programming and verification tests on circuit boards. You will ensure quality, operate various test instruments, and support production flow on the manufacturing line.

Applicants should have a high school diploma and prior tester experience; certification may be required. This is an on-site role with emphasis on safety and accuracy.