AIRCON INSTALLER

VANWARD HVAC INC.; Parañaque; On-site; PHP 180,000 - 240,000; Full time

Job summary

VANWARD HVAC INC. in Parañaque, Philippines, seeks an Air Conditioning Installer to mount, connect, test, and commission HVAC and ductless mini-split systems in residential, commercial, or industrial spaces.

You will inspect installation areas, review blueprints, secure units, braze copper lines, and perform leak testing while ensuring proper grounding and safe, efficient operation. A thorough handover to clients will follow with on-site cleanup.

Qualifications

• Inspect installation areas and review blueprints to select mounting locations.
• Secure indoor/outdoor units on brackets and pads.
• Core through walls for line sets and drainage.
• Wire power supply connections and ensure proper grounding.
• Pressure-test lines and vacuum test for leaks.

Responsibilities

• Mount, connect, test, and commission HVAC and ductless mini-split systems.
• Follow blueprints to determine best mounting locations and structural support.
• Secure units, braze copper lines, and route condensate lines.
• Test system pressures, calibrate thermostats, and demonstrate operation to clients.
• Leave sites clean and explain basic operation to customers.

Skills

HVAC installation

Blueprint reading

Electrical wiring

Leak testing

Troubleshooting

Education

HVAC Vocational Certification

Tools

Vacuum pump

Nitrogen pressure test

Copper brazing

Job description

About the role

An Air Conditioning (Aircon) Installer is responsible for mounting, connecting, testing, and commissioning HVAC and ductless mini-split systems in residential, commercial, or industrial spaces.

Key responsibilities

• Inspect installation areas, review blueprints or architectural plans, and determine optimal mounting locations for indoor and outdoor units to ensure proper airflow and structural support

• Secure indoor evaporator units and exterior condenser units using brackets, concrete pads, or roof mounts

• Core through walls (brick, drywall, concrete) for line sets and drainage

• Measure, cut, bend, flare, and braze copper lines

• Insulate refrigerant piping and route gravity-fed drain lines or condensate pumps to prevent leaks

• Wire power supply connections from the main breaker panel to disconnect switches, run inter-unit control wiring, and ensure correct grounding and circuit breaker ratings

• Pressure-test lines with dry nitrogen to check for leaks, pull a deep vacuum with a vacuum pump (typically below 500 microns), and weigh in additional refrigerant if lines exceed pre-charged lengths

• Start the system, verify operating pressures (subcooling/superheat), measure supply/return air temperatures, and calibrate thermostats or remote controllers

• Walk clients through operational basics (modes, remote functions, filter cleaning) and leave the work site clean and debris-free