Quality Technician: Injection Molding & Metrology Champion

Escatec Mechatronics Sdn Bhd; Gelang Patah; On-site; MYR 39,000 - 61,000; Full time

Job summary

ESCATEC Mechatronics Sdn Bhd in Malaysia is seeking a Quality Technician to support daily QC activities, ensure product and process quality compliance, and conduct inspections, measurements, and capability studies across injection moulding and assembly processes.

You will generate FAI, monitor Cpk, create CMM and SSV programs, verify containment actions, train QA inspectors, and help drive continuous improvement to meet customer requirements.

Qualifications

• Minimum 2 years of relevant experience in quality/manufacturing environments.
• Knowledge of injection moulding processes and common moulding defects.
• Experience in FAI, Cpk, GR&R and Trial Run measurements.
• Able to operate CMM and Smart Scope.

Responsibilities

• Supervise and support QC inspector daily task.
• Perform product FAI, Cpk and Trial Run measurement where applicable.
• Create and provide CMM and SSV measurement programs to support moulding production runs.
• Understand injection molding processes and its defect types.
• Verify containment and corrective actions are in place to address failures and customer complaints.
• Perform sampling re-verification of part inspection done by the inspector.
• Follow up of the problematic lot until it is properly disposed/rework.
• Perform machine and process capability (Cpk) study where applicable (GR&R).
• Monitor and ensure the quality conformance of in-process sampling and finished products.
• Conduct measurement training for QA inspector.

Skills

Quality control

Injection moulding

CMM

GR&R

FAI

Training

Education

Professional Certificate / Diploma in Engineering

Tools

CMM

Smart Scope

Job description

ESCATEC Mechatronics Sdn Bhd in Malaysia is seeking a Quality Technician to support daily QC activities, ensure product and process quality compliance, and conduct inspections, measurements, and capability studies across injection moulding and assembly processes.

You will generate FAI, monitor Cpk, create CMM and SSV programs, verify containment actions, train QA inspectors, and help drive continuous improvement to meet customer requirements.